Viewing all customer Discussions for:

Other

I have some old forever storm doors. The inside latches are broken. I'm good with replacing the whole latch "system". Can you help me with what I need to look for please? Do you need any measurements?

Hello I did manage to remove the sliding rollers they are attached by two screws at each end. And one adjustment screw goes into the side. Attached are photos but I did not take any of the rollers attached to the door. I could not remove the wheel as it is in a steel case. Each wheel can pop in or o ... (cont.)

I ordered this piece, but the lock lever is in the B slot instead of the A spot like my original. What do I do to fix this?

PLASTIC L BRACKET IS ATTACHED TO PLYWOOD WITH A SCREW. BRACKET CRACKED IN MULTIPLE BRACKETS. IS WEIGHT OF DRAWER CONTENTS STRESSING BRACKET TO CRACK?

It might be from Anderson thermo pane window

Looking to identify botht the handle and the keeper for an IWC patio door. Let me know if you ther info is needed.

Caldwell

I have no idea what part this is. Do you carry these hinges or something close to it?

29-5 HA2 CMC 24 Believed to be 1/2 in

I need 2 Channel balances. This one was not even hooked and otherside only has spring. The metal part (channel) is 30 inches long. Not sure if marking is saying 950 or 2950.

I titled the window and dismount the window. Attached pictures shows one of the sash lock is broken (a plastic piece)

it looks like the only numbers on this part is a patent number which is 2857233. I'm not sure if that is helpful or not! I would appreciate any help you can provide and locating a part that will fix this little gem!

These are Polygem windows. I need the clip that holds the Block and Tackle slide.

I have two of these doors, from the 80s I think. The first two photos are of the door I did not take apart. The mechanism in the other door was not working correctly, so I took out the screws thinking I could remove the mechanism. But when I removed the screws, the mechanism fell down inside the ... (cont.)

Hi There, The operator worm gear is worn out. Can you help me identify a replacment operator for my kitchen window? House is a 1948 mid century but I'm pretty sure all the windows were replaced before I moved in.

I looking to replace two (or more?) drawer track guides from a Basset chest of drawers. The curved ears on the bottom of two guides failed, causing teh drawer to fall out of it cavity upon opening. The track uses a wooden rail. The guide slides along it using teh clot above the ears. Do you ahve som ... (cont.)

The lock lever broke. This unit has a double lock - approx 11 3/4 length, 3/4 inch width. Do you sell a repair kit for the lock lever

No markings found

I sent you a picture of the latch, window socket where you fit one in, one taken out. I would like spring loaded slip in. I need four, two right and two left. I bought some the size was right but the tip was too long.

I am looking to replace this lock as the latch mechanism broke. There are numbers on the silver piece 7700B