Viewing all customer Discussions for:

Other

Spiral window balance attaches to this part and slides in track for window.

I need to purchase replacement window latches for 11 windows in my home. Are you able to confirm the part number I need for both the left and right side? Thank you.

First two shots are the broken window, the third is a good window in the next room. Is that plastic peice replacable? Home was built in 1966

1/2 inch wide by 35 inches long. Double hung non tilt window that weighs 16lbs. The only numbers I can find are 3425 near the bottom and there are no examples that match.

Where can I find repacement door slide on sweeps for Eagle Maximizer Patio inswing

Hello, I am looking for a Retainer strip for a guest, it is a green door, all he could give me for a id # is CBIFS36.

Picture of balance , serial number of windows. Hopefully you have replacements left and right side

Handle for Pella aluminum-clad sliding patio door. 7.5" high, screw holes are 5" apart. Doors are from approximately the 1980's.

Hi, I'm looking to replace my sliding door handles as one of them broke. I have three sets of sliding doors in my sun room, and would like them to match, but I am not sure what handles are compatible. Is this something you are able to help with? thanks, Chelsea

Hello, this bracket has 2 pegs that fit into the back wall of the drawer railing. Do you sell this part or know where I can buy it?

I have (3) Harvey Sliding patio doors. and i am looking to replace the existing door locks with a version that can be unlocked from outside with a schlage key. existing dont have a lock cylinder on the outside.

Need to replace 6

Good morning I need window replacement locks for my windows. Can you please identify this lock and do you have the parts? I need 10 of them.

$8

I need the tilt latches shown in the picture.

I just discovered that of the two sizes of windows we have, the other size has a triple coil, with a different cover. Pictures attached. Thank you. One more. I had a triple coil spring that was blown and got a pic of the imprint. Will, the spring for the triple coil be the same as the spri ... (cont.)

I have a sliding door made by Milgard that was installed in April 1997. There are two door rollers in the bottom of the door that have worn out - the wheel bearings are shot. I am looking for replacement rollers.

Hello! We need two cranks and one cover/crank. Can you tell which model we need? Thank you!

looking for two block and tackle sash balances for a single hung window. the stamp on the old parts reads 2530

Home guard storm door need replacement handle brass preferably