Viewing all customer Discussions for:

Weatherization

I opened this window and found the weather stripping in two pieces. One of the photos shows what I think it should look like if it was still together. The Patriot window information is in one of the photos. Round part is .25 inches. I need to replace one long side of each of the windows, the othe ... (cont.)

We have two swing metal doors that the felt has become very flat and worn out. I was wondering if you can help me with a recommendation?

All of the dimensions for our parts are available on the product pages on our website. In case you missed it, here is the diagram:

I?m looking to replace this flattened bubble seal. I?m not sure of the exasure of the dimensions

Looking for some assistance with replacement weather stripping for my home windows (built by NuAir Manufacturing in 2006, single hung aluminum). The stripping looks exactly like your item 58-135 with one exception (the t-slot is a bit more narrow at roughly 5/32). Do you carry something like that? ... (cont.)

Hollow bubble seal. Has a flat fin on one side. And a T slot on bottom

I HAVE A SLIDING GLASS DOOR THAT WAS INSTALLED IN 1994. I THINK IT IS A PELLA OR ANDERSEN SLIDER. I NEED TO REPLACE THE WEATHERSTRIPING THAT SEALS THE BOTTOM OF THE DOOR. I AM INCLUDING PHOTOS.

My Kolbe and Kolbe crank out windows have a 1/4 in. bubble. the one you list is 5/16", will this work or cause a problem? Also is the spline of the seal ridged? Thanks Jeff

I want to replace the weatherstripping for my M & W windows that are about 18 years old. I can?t find this particular weatherstripping piece anywhere. I did check your website and didn?t see anything that matches. Can you recommend a piece that can be used to replace this. Thank You ... (cont.)

Foam 5/16? ?Leg? 5/16? Fins 1/4 hard plastic

Can you provide replaced material? We are repairing from hurricane Irma. Need material for slider doors.

what are the dimensions of 58-180? it it the same width on both sides of the V?

Will the foam with nail flange work on and arched door jam?

i have exactly the same situation excwpt that my doors swing out and the astragal is on the inside of the non-active door. However the is no slot for a kerf on the weatherstripping that attaches to the astragal. I would prefer and adhesive type over something that had to be nailed over 80 inches. ... (cont.)

What I would call weather stripping might be called something else. What I am looking for is the thin fuzzy strip that is in place at the top of the lower window. This is for Carefree manufactured home windows.

Overall Measurement is Approximately 1" The Solid bulb is approx. 3/8" Diameter The bottom of the the vinyl "I" beam is 1/2" The top of the vinyl "I" beam is 1/4" Total height of the "I" beam is 1/8" The distance between the top and bottom "I" beam is 1/16" The thickness of the "I" beam is approx. 1 ... (cont.)

I am in need of weather stripping that goes between the stationary panel and the sliding panel. It appears that over time, t has shrunk in height. This is for a late 70s or early 80s sliding deck door that measures 80" high by 72" wide. The door still works well and I am just trying to buy a little ... (cont.)

Pella Entry Door has this identifying number: F0100107842 03/05 NFRC5/8 kerf center to center along grooves

I'm looking for lower sash bottom weather stripping for gorell modell 5305 double hung replacement windows. Gorell is out of business I think the part number is 58-182. If possible please confirm

Need a replacement bottom sweep ... thx