Viewing all customer Discussions for:

Weatherization

Storm door model 248-TL Built 3/10/1998 Registration # 024881U.111980310 Door has two sweeps

This weatherstripping is from the bottom of the lower sash off a double hung window. The angle is about 1/4 inch on each leg, the included angle is a little less than 90 degrees and the bubble looks like it started out as a cylindrical tube about 1/4 inch diameter, although it's now pretty flat. ... (cont.)

WE HAVE A NEW COMMERCIAL STEEL ENTRY DOOR & FRAME THAT THE CONTRACTOR INSTALLED A TUBE SHAPED WEATHER SEAL ON THE FACE OF THE STEEL DOOR FRAME. IT HAS BEEN INSTALLED ONLY 2 WEEKS AND IS VERY UNSATISVACTORY. IT LEAKS BAD AND HAS ALREADY SHRUNK TO THE POINT THAT IT LETS SNOW INTO THE INSIDE OF THE DOO ... (cont.)

need some pile window weather strip for silverline 1200 series double hung window. the factory strips are small & light can be seen though between sash & frame.

Looking for 9 Lft of the rubber strip for our walk in cooler door sweep.

We have 2 types of door stripping between the doors. What items are these two that we should order? Please see pictures attached.

I am looking for the item shown in the attached picture. It is the grey felt lining that goes in the upper rails of my closet doors and the door rides in-between. The felt is missing in one of the rails. The closet opening is 6'1" wide.

Hi, I am looking to replace window weatherstripping throughout home. I have attached photos and dimensions. Please guide me to your closest product.

Please identify this

General contractor, commercial out swing wood double doors with recessed spline down the center that holds the astragal pictured above. 3/8 wide, metal 1/8" and do not know how high the wool pile was before but probably 5/8" where do I get this part

This seal was taken from a republican type window.

Please tell replacement for the sweep for Stanley Door Systems 251271, A3300-354 It's a white steel door with large window upper half of door; pics show the sweep has three or four strips running along bottom of door, the last 5 inches of each has been worn away leaving gap. Cannot tell how to remo ... (cont.)

Hello! I need weatherstripping for my front door. The problem is that the kerf slot is 90 degrees off from the conventional location (please see photos). I would like to take advantage of the kerf and install weatherstripping with a kerf barb system, not peel and stick weatherstripping (I just remov ... (cont.)

This is for a glass double door (storefront). Wool pile is 3/8 wide and a depth of either 1/4" or 5/16" with a length of 7'. this weatherstripping back plate is metal that goes in the door track it has spring action clips and is held in place by screws going threw the wool weatherstripping ... (cont.)

We purchased part #58-050 and the pile is 7/16 it is to high. The 7/16 base is what we need. We need a door strip that is 7/16" X 1/4"or very close to 1/4". Thanks for looking, CC

Looking for this weather seal for a craftline wooden window

Spoke to you Wednesday afternoon. I am sending you a few pictures from my cell phone of steel front door weather stripping. This is picture of weather stripping from outside hinge side of door. I sent a few shoots. If you need any other shots please call or email me. Thanks

This is for older Thermal/ever guard windows with Truth hardware. Im worried about removing a sample because its becoming brittle(sun damaged)and it seems to be really attach well to the sill-frame. Im guessing that it could be pulled-out like most weatherstripping.

Hello I work for a school district and the weather stripping between our 2 dock doors has gone bad. Do you guys carry any models that look like the picture I sent above. I included a picture of the tag of the door and the make, I think it's a Stanley . It is 84 inches long... The stripping that is. ... (cont.)

having a hard time locating a weatherstrip for my Crestline SGD's from the early 90's. Does anyone have any in captivity, or a functionally equivalent replacement?