Viewing all customer Discussions for:

Weatherization

hello, I have old Certainteed casement windows and the weather stripping is coming off all of them. i would like to replace the weather stripping. I have included a picture of the weatherstripping. it is bubble seal with 1/4" width of bubble and 1/4" length of base extension. If you could point m ... (cont.)

I am looking to replace the window seal indicated in the photo submitted. The measurements are shown in the background measure. Please advise. Thanks, David

Hello, I have several Norco (casement) crank-out awning windows for which the weatherstripping on the frames (not the sash) has failed. I've included a photo in the hopes that you can help identify a suitable replacement material. Thank you, Tom

I see you offer magnetic weather-strips for metal Stanley doors. Photos attached show cross-sections end-views of my Stanley weather-strips: magnetic (top and latch side are same) and compression (hinge side). The door is stamped only

Hi, My name is Lou, my wife and I live in Sistersville, WV where we purchased our home in 2010. The back side of our house has some old aluminum storm windows that the insulating stripping is gone. This weather stripping sits in a groove in the aluminum window frame. I'm able to put a 3/32 drill bit ... (cont.)

We need to replace window gaskets on 1960s era sliding door frames. The material appears to be plastic or hard rubber. The gasket fits over an aluminum channel on the door frame, and snaps into place. SIZE 1/4" base, 3/16" sides. (door frames are appx 8') Thanks, Mark

Can you provide the weatherstripping shown on the attached? It came with Woodco casement windows manufactured about 1975.

I need to replace the weatherstrip of my front door. Here is a picture of it. The base is 1-1/8" wide. My door is 8' x 3'.

I have a client with casement windows who needs many of them re-weatherstripped. This is a photo of the product, do you have something like this?

Are there any videos showing how to replace a t-slot bulb seal?

need to find rubber strip or weather strip for the bottom of the bottom window

Hi, I attached pictures of two different piles in my window. IMG_1376 and 1380 are of the first sample and IMG_1382 and 1382 are of the other. I believe the first is 5/32X1/4 and the other believe is 9/32X1/4. The last picture is of the profile of each. The first one on the left and second on r ... (cont.)

looking for a replacement for this seal

This is the bubble weatherstripping at the bottom of my windows. The channel if fits in is 1/8 inch. The measuring the bubble diameter at 9/16.

I am looking for this prime door sweep with tabs. I can't use something like 58-186 as a replacement because I have kick plates on the door. Do you have any suggestions?

My customer requires a replacement entry door bottom seal. I attempted to use 58-189 but it would not work. The center tabs on the bad seal two attaching tabs are spread apart slightly more than on 58-189 and they are a little higher and they had an angled edge on the outside top that hooked on the ... (cont.)

Is a special tool required to install #58-135 or #58-134 insulation at the bottom of a window? Does the sash need to be removed before replacing the insulation strip?

This is weatherstripping from the frame of a commercial entry door. If it doesn't look familiar I can mail you a section. Thanks. Bob

I made a drawing, but I did not have a program to convert it to any forms that you would accept, so I took a photo of the screen. The second photo is the profile I was drawing. the third shot is the outside side of the strip. Will the bubbles keep the window from going down far enough to lock? ... (cont.)

This is for survivor 5500 windows.