Viewing all customer Discussions for:

39-084 Crown Window Crank, RH

Attached are pictures and dimensions of a window crank operator that I believe is or close to the 39 - 084, but there are some slight differences. The 2 holes at the bottom measure a center to center spacing of 1-3/16" whereas the dimension you show is 1-1/8". The arm extension has a clearan ... (cont.)

Hello: I am in desperate need of two replacement crank operators for my porch casement window. They are Permaseal window. Any help would be greatly appreciated!

I need help choosing the correct jalousie replacement handle. I've attached two photos. can you help?

I have a small bathroom window in a house I just bought that didn't have a crank/operator. One was left new but it doesn't line up as the window arm angles over directly in the way. Also the bottom screw holes are NOT two side-by-side rather the outter one is a bit higher. House built in early ... (cont.)

Hello, I have a handyman that will replace these for me if I order the parts. He wants to charge me $50 per window and I have seven. He said if I got the parts he could do it for $15 per window. Can you help me identify the parts that I need to replace all of the mechanisms. And a cost for each. Th ... (cont.)

Looking for replacement window cranks for old aluminum windows

What is the height offset for the two bottom holes for this crank?

My window crank from my 1960s vintage awning windows(Photo1) The numbers inside the crank body are: AT.No. 198202 U.S. RD.1963.CAN Dimensions are very close, I have put them in White on a copy of your dimension photo(Photo2) As noted, the length of the 1 arm and the hole are the onl ... (cont.)

THIS IS RH old windows in florida crank out bathroom 26x63 window 3/8 screw connection can u help

There are no names or numbers anywhere on the windows. the straight bar hole to hole is 2 inches. top hole to middle hole is roughly 4.5 inches. Strait bar is threaded on the end for the screw. Please help. Whole housing is about 1 inches wide.

Trying to identify a crank replacement. These window are from the 50s/60s I believe. Will also need double groove pin, clip and washer. Thank you.

Have a Permaseal window with a mal functioning awning window operator as shown in the picture. The width is 3/4in. The vertical distance between the screw holes is 4.5 in. The top hole is 5/16 in. to the left of the bottom hole. the total height of the operator is 5 7/8 in. the depth of the operator ... (cont.)

Can not find any names, numbers markings.Windows probably from the 1960/70's This house is being restored. HELP

I have looked at your parts and I have found ones that are close could you help?

Good afternoon, I just purchased a house in St. Petersburg Florida, it was built in 1953 and I need a replacement for one of my windows. It is my sincere hope you can help me out. Cheers,Kevin

sent pics

Can you please advise the part number to the window crank in the attached photo, along with a link to it? The crank is stripped and will not close the window. Ed

Need replacement part identification help - 13 of this type. Inside housing are stamped:Pat. No. D 198202 U.S.H RD 1963. CANOn connector arm there is stamped: 78On connecting arm rivet there is stamped either 16 or 91Inside the handle is stamped 11 500 11 Pat Pend

Need replacement

I tried one by guessing 39-278 but was just wrong - almost but wrong screwholes/locations. Can you help me identify the correct replacement part? Thanks.