Viewing all customer Discussions for:

39-107 Truth Hardware Operator Cover

window will not crank closed. Opens fine. Plastic cover piece is cracked.

Do you have 2 cranks and 6 window crank covers to fit Vetter windows?

Hi I need to replace two right hand and two left hand hinges (cranks?). Can you tell from the pictures but I need? Tom

The old handle is from an Eagle window made around April 2005. The old handle has a set screw to hold the handle in place. The set screw fits into a recess beyond the splines. The old actuator handle is 11/32", the depth of the 39-114L splines measures the same as the old handle and there is the sam ... (cont.)

Operator does not work, is this the only piece I need to replace?Left Lock

I need 5 replacements, can you help me?one with trim and handle. To be clear, the bad cranks are all on the lower right side of the window as you look at it from the inside.

I need a right hand and left hand of this item. I also own a glass and glazing company so if I I need to buy this commercially I can.

Need part for the window with following identifiers: SNE IGCC CPA

This hardware belongs to windows we bought 25 years ago. The windows were made by Pozzi who I believe sold out to Pella windows. Written on the hinge is the name "Entry Guard"I would like one of them but would purchase several to have on hand. I would really appreciate your help as the window can ... (cont.)

I need the same left window hardware. 45179, the short arm says L 31538AI'm going to need 4 replacement cranks.I need the entire hardware, not just the cranks

I have a left swing window and a right swing window as pictured. I want to be sure I order the right parts.

you can see in 0-2.jpeg that the plate has broken at the bottom screw. THis is I believe lincoln patio door hardware, butI don't have any parts numbers. I did measure as below. I used a the measure, and while I tried to see 15/16ths, I might've missed a 1/16th here or there. Do you have just the ... (cont.)

Do you have this part ? The last picture I attached is a part that is 6". Do you have the operator with that 6" arm ?

Need to find 2 replacements ASAP. Can open but not close the window. House built in 1986 and Bilt Best Windows are no longer made. This is 5 1/4 " long and 1" deep. Can you please help?!

My mother needs to replace handles and covers on her Kolbe Windows. Age of the windows are unknown. We think these are the original windows from when her twin home was built approx. in 1987.

need 13 window cracks like the attached and 13 covers (white)

i measured 9 1/2" crank arm and 5" casing on interior

as shown in the picture, please let me know which part I need replace. Thanks a lot

Hi Swisco! I am looking for the entire assembly for this crank out casement, the handle, cover, gear, arms, sliding guides--and all of the other parts I am naming incorrectly! Basically I want to have a full replacement set available for this window. Can you help based on the photos I have suppli ... (cont.)

I have one right hand and one left hand casement windows with the same problem and need to replace the operator(s). Please help me determine the replacement part numbers and prices.The straight arm is approximately 9 inches longRichard