Viewing all customer Discussions for:

39-160 Left Bottom Rail Bracket, Andersen

Do I have to use Anderson or can I replace with swisco?

Hi, replacing a few operators and need help identifying the right replacement. Thank you!

I need replacement parts for 3 Anderson windows. 2 are the first image. Don't know whether 4 1/2 or 8 3/8 arm need 3 cranks also.

I ran into the open casement window while mowing lawn with my John Deere lawn tractor, the bagger caught the window, and has bent the mechanism. I was able to close the window by pushing it closed from the outside, but the window is not at all usable. A gap now exists on the lower half of the wind ... (cont.)

Not sure which series windows, since there are no stickers or codes anywere. I uploaded all parts, I have several windows. All very hard to open and close, house located off the dock so sea air and several years of no maintanance have made very hard to use.

The windows are hard t open, house sits off the ocean water, so could be the salt in the air, affected the operation, especially since previous owners didnt maintain the windows

Looking for these hinges

I am looking to replace broken cranks and window locks.

Need bottom of window arm Pin is broken off

I can find crank assembly but not the stainless slide and plastic stop that fits in it? Please help. Thank you

ONLY NEED (1) FOR NOW. THANK YOU!

Hi, I am looking for two Anderson casement Window replacement parts. It looks like I need the whole mechanism to open and close the windows. Please see photos Regards, Joe

The number I can find on controller is 1361318 Do they come is left & right?

I need to replace several Anderson window crank assemblies. The part number is 7177-31 R H

It has been difficult to crank open and close without helping the window by pushing or pulling. Attached find pictures of the crank assembly parts for your identification purposes.

The picture is of the corroded arm on an Anderson casement window. I don't know the age. We live on the coast so that may be the reason for the corrosion. I have not taken the part off as I wanted to check first to see if it is feasible to replace these parts. If it is possible to replace I will ... (cont.)

Hello I think I have a few straight arm mech and dual arm that need replacing from 1985-88 or so.

Loooking for replacement parts

two separate windows House built in 1959 say Anderson on them

Hello. I have Andersen casement windows. Two pictures attached. I want to replace everything, including the handle. Is there a kit that comes with everything?