Viewing all customer Discussions for:

40-049 Complete Mortise Lockset, Brass

I want to have a replacement storm door lock set for the PADO PATENTADA (1.5 inch Door thickness, please see the attached photos).The length of the front and back lock panel is 7 inch, the tow screw distance in inside and outside panel is 6 3/4 inches. I would be appreciated you could let me know t ... (cont.)

Need new door handles inside and outside with the plates. Lock is fine. PPG Herculite K. Tempered safety glass. CAN/CGSB.12.IM. 16CFR1201 CH. ANSI. Z-971 1984 ItU. SGCC 250 6023905. ...

A

Broke the key inside of the cylinder and cannot get at r made

I am on the mad search for a replacement lock for my Trapp storm door. Will your 40-089 work in this lockset. My existing lock is an oval shape with the same dimensions as the 40-089. Thanks for your help.

chamberdoor handle 322n

I wanted to know if I could order this door handle. This one is broken.

Do you carry this part or a replacement that fits the existing hole patterns in the storm door?

These are the locks I'm looking for PADO, hope you guys have one.

I have a Storm door on a rental that has an Emtek 322 that is not operating properly and needs to be replaced. I have done a bit of research and it appears that the SWISCO 40-049 would be a direct replacement, am I correct in assuming this?

Can I replace this old emtek lock with your 40-089 key tumbler thumb turn? See photo.

Looking for a replacement for this PADO LATAO lock. Front Brass plate: is 7 1/8 inches long, mounting screws are 6 3/4 inches apart on centers and the plate is 1 inch wide. Edge Brass plate: is 7 1/2 inches long and 7/8 inch wide. Latches are 2 inches apart. Upper latch is handle activated, lo ... (cont.)

Security door handle needed

Handle keeps falling off because the spindle is broken

Older steel door and lock, late 70's/early 80's. On the outside plate on top is the word "PADO" and on the bottom is "LATAO". To me, it looks similar to the 40-049, and this is the only site I seen that has these similar locksets. The newer mortise locksets have wider plates that simply will not fit ... (cont.)

I just bought a used screen security door (no idea what brand) that did not come with any hardware. The Larson Brass Mortise Lever Set, Product Code: 40-211, looks like it will fit but I need a 7/8" backset and the screw holes on the face of the door are 7 1/2" apart (compared to 8" on the Larson). ... (cont.)

Looking for the above replacements.

I recently spoke with someone from customer service who was going to attempt to find a replacement part (most importantly the spindle) in order to fix this door handle. She mentioned that she needed a picture of the door. Attached you will find two pictures.

I have a ole Sewell storm door registration number 0016989003036. On the handle plate it says Emtek 322. In my second picture I have included all of the measurements I think you would need to see if you have a replacement handle for the door. I would need the face plate and all of the handle and ... (cont.)

Hello, I am looking at replacing my front door lock (see attached images). The existing lock is "Wright" brand. Do you have something that will work on my door? Thank you, Haseeb