Viewing all customer Discussions for:

40-150 Inside Handle, 1-3/4"

It was on a Larson Door. Inside is a lever handle with a small piece turned into a groove to keep the inside level from turning. The outside is a lever handle. A square bolt goes through the door to turn both inside and outside lever handles. The outside cover plate has a part number 1751-1. The out ... (cont.)

Hello. You're my last hope. I don't know who made the door, but it's about 15 years old. In photo #1, this is the entire piece mounted on the inside. The top handle assembly is the problem. Photo #2 is the assembled handle on the door outside. Photo #3 shows the problem. Center top in the latch. Und ... (cont.)

Just need the picture, I have the shaft and handle, may need any hardware needed.

I have a Cmech outside storm handle that is broke. Where can I get one and how would I go about ordering it. I only need the inside handle but the outside round brass door knob is tarnished so, I'd like to get that too if possible but the inside handle is really all I need. Please advise! ... (cont.)

This handle is a near perfect match for the broken Pella handle I needed to replace. However, the spring loaded stopper doesn't quite have enough clearance to pop past the catch on the frame. Is there a latch that matches this handle?

Wartian SD-1100/1200 Standard Inside Latch My latch says DBL 1100-6

Colesewell estateseris es354233

Looking for a replacement for the uppers handle everything else is fine

Looking for a replacement screen door handle and deadbolt lock. Deadbolt dimensions same as your 40-058 but handle base doesn't match - mine is 3 inches instead of 4 3/8 inches and the door swings in not out. Thanks!

I need to replace this storm door handle assembly and the deadbolt with key below it. The door is a Cole Sewell Thank you

I have a broken inside handle. Unfortunately I do not have the missing piece. Looking to purchase a new inside handle

I need to find a replacement storm door handle for a door that is 1.5 inches thick. The screws are 1 3/4"apart and set back from the door edge by approximately 13/8" - 1 1/2".. Do you have anything that could fit?

The second picture show the handle In the up right installed position. Meaning the keyed lock is on the top. The bottom handle is broken

The plastic knob latch has broken. Need a replacement door handle part. Andersen Screen Door serial # 302070762.

I am looking for a replacement handle for this Cole Sewell door

Pella screen door

Hi, looking for the correct inside handle broken. The outside handle or a complete. Thanks

Pella screen door latch

Inside door handle on my Cole Sewell storm door does not spring back to a horizontal position so that its nose sits against the vertical bar attached to the door jamb. From what I have read, it looks as if your 40-150 model might solve my problem. The outside handle seems to be working properly. ... (cont.)

Door wants to catch when I turn knob.