Viewing all customer Discussions for:

59-001 Sash Stop

I think this part retains the spiral balance. As you can see it's missing on one side of the window. Do you have a replacement? Thanks for any advice!

Thank you for already ID-ing the tensioners and knife shoe stops. Now I need two pivot posts and - if possible- rubber travel stops. The one in the pics is old and hard. Hope you can find something. Mike - contractor

the channel balance is number 2230P. 1720P AND 2840Z. I NEED PART NUMBER FOR REPAIR MY WINDOWS, THANKS FOR YOUR HELP

1/2" channel - Set1 Channel only (excluding plastic) Overall length 32 5/8" - Marking 32 5 B.SI PCSet2 Channel only (excluding plastic) Overall length 25 5/8" - Marking 25 9 B.SI PDSet3 Channel only (excluding plastic) Overall length 25 5/8" - Marking 25 5 B.SI PDSet1 29lbs windows about 34x36 (need ... (cont.)

Hi Steve, This Oscar we spoke yesterday in regards to the type of balancer guides I need, and window stop, hopefully this pictures help. 33''x1/2''x1/2''

I have looked through 400 pictures on your web site for this screw that has a hex head that is 5/8

Hi - I need some help with quite a few parts 'Firstly I am looking for about 6 take out clips - I assume they are pretty standard ? Then, I need quite a few channel guides the interior width looks like 7/8 inch - here are some pictures - do you think you can help me locate these ? Some pictu ... (cont.)

Hello, I have replaced some of my sash balances, and all is working well. I notice that if I push the window up too far, past the Yale stop, the sash balances become disengaged when I pull the window down again. Are these stops intended to prevent the window going up too far? Thank you, D ... (cont.)

I'm looking for a rubber piece that screws into the side track of a window that will prevent the window from opening the full height. It is for 2nd floor windows to prevent a child from falling out of an open window. The track is 3/4 " wide. Thank you

I watched your video on removing a non-tilt window sash, but... my 1978 windows do not have viewable take out clip. It only has, at the top, a screw in a little aluminum clip. Aluminum windows. Can you tell me the procedure for removing. I am asking because of the difference. See pic attached. ... (cont.)

Need to replace 29"/2820 and 19"/2810 Channel balances in a 1971 house. I think they are 370 series. Will need also sash tops, capitol lock, and the two pronged clip that holds balance from the top (which I did not find pictured anywhere). Please see attached pictures and advise. Thank you. ... (cont.)

I know you offer 59-001, it shows in the picture that the dimensions are 1" x 3/8" x approx 3". I've measured the sash stop from my windows, it measures 1 3/16" x 3/8" x approx 3", and the track it fits into measures 1 1/8". The block I have looks the same as the block pictured, only a littl ... (cont.)