Viewing all customer Discussions for:

70-009 5 Pack, Screen Plunger Pin Latches, 5/32"

Trying to replace aluminum screen profiles. Everything sold now does not have retainer pins. Can I by these pins and drill the holes for pins?

do you have a 25 pack of the 70-009

I need a few replacement pins for the screens. The pin has a clear cap at the end. Is this the plunger pin that you have online?

Would you have the part identified in the photos attached

is there any option to purchase the compression springs themselves instead of the whole plunger latch assemblies? All of mine have deteriorated over time, but I don't have a need to replace every single plunger latch in the house. I'm looking at 70-009 or 70-136 Thanks.

I ordered #70-219 they are to short These screen are off of MArvin Windows Can you figure out the correct part number? thanks Mike

I just missed it on your website, but where would I find top fixed anchor pins for my old peachtree window screens as well as how to replace them since many have broken off? All I can find are plunger pins. The screens have 2 fix anchor pins at the top, and on each bottom side is a plastic latch. ... (cont.)

Hello, Please help me find the right screen insert pin. Picture is attached. Thank you, S

I need to buy replacement plunger pins for a screen part #A-X7164. Thanks

Plunger is approximately one and one eighth inch long. Cannot pull out of screen completely Please advise what to purchase Thanks PATTI

I might order these if I could see how they get installed. Unless the ring detaches somehow, they can't possibly go in the same way as the regular plastic-capped pins.

I am looking for 1" push pins for a couple storm windows. I was told I could find them thru this company. These screen windows have two on the top sides and bottom have two on bottom but these pins are more like plugs then the push pins. Can you let me know what you have available and where I can fi ... (cont.)

Need replacement tension springs for Window Shield screens. These spring into a groove in the outside metal window frame. The springs are 1.5" in length. The plastic pull on the inside of the springs has broken off of most all of our windows. We need 40 springs.

We have several missing screen push pins. We have JeldWen double hung windows with a screen that attachs on the outside using the push pins to hold them in. The end of the push pin is pointy not flat. Can you tell me what we need to order

I would like to order and replace several screen tabs for my integrity screens. Please see attached photos and let me know how I can order them and/or what parts number I should use

Hi, folks. The screen pins in our double-hung Marvins take a beating in direct sun and the plastic snapped in one this summer. Is one of the parts you show at https://www.swisco.com/plunger-pin-7-32/pd/Replacement-Pins-For-Screen_Storm-Panels/70-008 the replacement part I need? Thank you for the ... (cont.)

Trying to find replacement parts for broken pins on peach tree screens. Also, how do you remove broken off pins in screen frames?

Screen Pins--please identify and then purchase

Hello:The screen pin images on your site do not overall length. My old pins appear to be about 1.5 long with top cap on. See photo #1The "stick out" length is indicated in photo #2.The UV light has made almost all of the old pins brittle - is there a quick way of removing the old assemblies without ... (cont.)

I own Marvin Clad UltDouble Hung windows and are in need of replacing push pins on the screen . Model number 407-H-1127