Viewing all customer Discussions for:

70-009 5 Pack, Screen Plunger Pin Latches, 5/32"

Looking to buy two new screens for my condo windows, just to update the look. They contain four "plunger pins" I believe they are called. (they pop in and out in order to remove the screen at any time) I would like to purchase 2 of these and 8 plunger pins. Any ideas? The window screens have this ... (cont.)

I need the pins for the screens as well as the corners for the screens. I also need the seal for the bottom of the window. I hope this helps us figure out what we need from you.

These are from a 2015 installation of All Ultrex (I believe now they are banded Marvin Integrity) single hung windows. The pins in some of the windows broke and some do not have the springs. I would like about 10 pins to replace broken ones and have on hand for future use.

- Alloy tapered pin - Tapered pin length 13/32 - Overall length 1 1/2" - 1/8" shaft diameter - Shaft length 5/8" - Spring length 1/2" 3/16" spring diameter - Alloy end button 7/16 in length

Hello, I just recently placed an order with you for plunger pin assemblies for my home screens. The order number is #1661630 and the part number is 70-219. I found you by typing in the number from the screen in a Google search field (A-X7164 shown in the picture above) and your company website pop ... (cont.)

Hi - I am trying to fix my screens which are missing a few plunger bolts and corners. The tops of many of the screens have bolts that seem to be the same as the plunger bolt but just inserted into the frame - no spring or plunger or hole on the bottom of the frame. Do you know anything about this ... (cont.)

Trying to locate this part that dates back to 2001 M&W windows. Would appreciate any help! Thank you, Dave

:looking for replacement screen plungers for my window screens

Installer on trimline windows claim can't get parts. Can you help

Your plunger pin 70-219 shows 7.32" diameter but the width of my screen is only 5/16" and the existing hole is only 1/8". Do you have a plunger pin that will fit this screen? Only one plunger pin is missing and the other pins are about 1 1/16" long, which means 3/4" of the pin is in the screen and ... (cont.)

Hi, I need help identifying a replacement plunger for my screens. The tip is 1/8" OD and the length of the metal part is 1 9/16". It has a black cap. A picture is included. Which plunger model should I buy? Thanks, Joe

need help getting the same plunger for my screens. need about 100 of them

I need 4 of these for my window screen. Plunger woth spring

I'm looking for a side pin for my full screen. The Windows are (Bonneville) which went out of business back in 2014. Do you have anything for this type of screen . Thanks

Metal with plastic tip

Hello,Truing to find a replacement for these. They are 3.5 inches long. There is spring missing from the one in the picture. Can you help?Thanks Frank

Are the 5/32" window screen plunger stems made of aluminum? We live along the Atlantic coast where ferrous steel corrodes rapidly outdoors.

This is the original from the screen. It had a spring also that was stuck in the whole. No markings and Nu-life replacement part does not fit. Thank you for your help

Hi, I have 20, 24 year old Marvin Integrity windows.Looking for screen pins that would fit without drilling to the screen frame.On your web site I saw several Part numbers.Is there a specific part number pin that would fit my screens without drilling the frames.Thank you,Joseph

This is one of two pins located in the top of the screen frame that holds it in place. Approximate dimensions are 5/32in x 1-1/16in threaded on one end.