Viewing all customer Discussions for:

75-006 Spiral Balance Charging Tool for Tilt Windows

There are no markings anywhere.It's a condominium complex. "The Pines" It was built in 1985 in SHOWLOW, AZ 85901. Are you able to figure out what brand these windows are? I would need the hardware for two windows left and right side. Tilt locks, tilt guides on bottom of tilt window, left, and right ... (cont.)

Hi, none of the 6 double hung vinyl windows in the house I just bought will stay open. The spiral is the same for all of them. 31" long, red tip, looks like the s400. In a few of the windows that I managed to force up, the red tip was shattered. There's grease everywhere. The windows are marked 198 ... (cont.)

Hi, Hope you can help me select the correct Pivot Shoe for my older Vinyl Windows (30+ years old). Attached are photos of the current Pivot Shoe. I believe it's 5/8" thick x 1 1/4" width x 2" Height at corners (Note: Height at center is 2 1/8")Looking forward to your guidance. Thank you, ... (cont.)

Above is the sticker for the widow and a picture of the parts I need. The shoe is 1/2 deep and 1 inch wide

Looking for part for Sunrise slider windows

29" long, 5/8"

I need 14 red tip spiral balances. They are 26" tube...3/8" wide tube . Also 6 green tip spiral balances 26" tube 3/8"wide tube . 10 pivot pins . 4 tilt lashes 2.5" long by 5/16 wide . Thank you Jim Schuler

The part I'm looking for is 15" long and I think 5/8" wide. (Although it looks like 1/2") and has a blue tip. I will need 4.

Looking for the possible parts or equivalent

I am looking for the correct lock shoes for my American Craftsman series 8500 double hung windows. The shoe is basically 2 inches from top to bottom, 11/4 inches from side to side and roughly 17/32 inches from front to back.

Hi. Can you please identify the part that has to be replaced in these photos? The footings that connect the spirals to the window sash are cracked.

Hi, I’m trying to replace Better Bilt window balancers, I’ve identified the 28" long and 3/8" thick, Series 900 red tip Spiral Tilt Window balancer as a possible replacement. Do these photo’s confirm this model?

What pivot shoe is this?

This is the pivot shoe that I'm looking for. I thought 15-118 would work. My shoe is 9/16th x 1.25" x 2.190" my question is do you have the exact shoe or would 15-118 do the trick? Pls advise .

I would like to order parts to repair the spiral balance assemblies for 5 tilt-out windows (Acorn brand?) in an ocean-front Florida apartment. Window glass (single pane) and casings in good shape but slider hardware is badly corroded from the salt air. Sash weight is best guess ~20 lbs. Sash dimensi ... (cont.)

35" long 5/8 wide balance, the twist mechanism and the pivot bar . Could you recommend the proper parts could not remove the parts because I need the windows in place and if the parts break it won't fit back in

I have an aluminum frame tilting window that wont stay up. I recently replaced the spiral balances with two 3/8" W 16" L blue tip balances but it didnt solve the issue. Upon further inspection it looks like these plastic parts holding the balances are cracked or broken but I dont know what to replac ... (cont.)

I'm looking for price and availability. I'm needing 6 units

I need replace part

Hi, I just bought the house and discovered some window problems. I don't know the window brand, but I suspect Ashland. The spiral balance does not appear to follow standards: it is 35" long, the tip is faded but I think it's yellow, but the diameter is 53/128 (almost 7/16"). I cannot remove the s ... (cont.)