Viewing all customer Discussions for:

81-018 Sliding Patio Glass Door Tandem Roller

Hello, attached is a photo of the glass sliding door tandem roller assembly that I need to find. I am sorry, I don't have the measurements. The assembly is approximately 4" long x 2" high. Please advise. Thank you, Jim P

My Anderson sliding door was installed back in the mid to late 1980's. Door works fine bine getting hard to roll back and forth. How would I know what model roller to buy? Can't find model number for this door. Does one size fit all?-Thanks!

Need rollers for sliding door. Sliding door is 48" w by 78"high and was new in the mid 1960's.

Hi We are looking for a replacement for the bottom track and rollers on a ppg herculite k sliding patio door

1ST POST HAD 3 PICTURES AND DIDN'T GO. 1 PICTURE ATTACHED. GOT TO BE PART # 81-149. ALL MEASUREMENTS MATCH. ANY IDEA WHERE TO GET THE WEATHER STRIPPING THAT IS IN THE SAME CHANNEL AS THE 2 SETS OF ROLLERS. I DAMAGED IT PULLING OUT A ROLLER. CHANNEL IS 3/4" BY 35 1/2".

Truth 30410

I just wanted to be sure that I have the right part number when I order. Thank you for your help!

length 5 3/4" center of hole to center of hole wide 3/4" tall 1 1/2" housing bottom to top weight bearing cleats roller 1 1/4" diameter x 5/16" wide

Greetings , repairing 8 heavy wood patio doors. Need all new rollers , some handles and weather strip along to top and jambs also interlocking strips. Can't find a name anywhere. Glass is marked cardinal 1986

My Caradco 12 sliding patio door does not roll. I tried adjusting the rollers but I do not know whether to turn the adjusting screw clockwise or counterclockwise. I had minor success. Perhaps I need new rollers. The sliding doors are 22 years old. Do you suggest I replace the rollers or simply ... (cont.)

I need new rollers for my Anderson Perma-Shield Frenchwood Patio Door. I purchased it in 1992 and the rollers are worn out. I have the papers to the door but there is no item number. Can you help me?

I would like to replace this wheel assembly. Do the wheels straddle a track or do they ride completely within a track? Thanks for your response. Mary

2 off patio door rollers part no.truth 31761

I would like replace the rollers and door handle/lock.Do you carry parts for the above mentioned model. Thank you, Howard

The sliding door is wood but has no indication of the door mfg that I can see. The part I need most is the 35 1/4 inch plastic "sleeve" into which the dual rollers inset. The plastic sleeve also has weather stripping "fur". There's another same size door that needs sleeve replacement. In additio ... (cont.)

With your replacement rollers, when the rollers are pulled all the way up, do they stick out, or down past the side rails making it impossible to get the sliding door on the track? I just bought two replacements from Lowes and this was the problem.

Caster 31761A

PE Del Mar, the manufacturer of this roller assembly sells in large quantities to retailers, they suggested I check with Swisco which is an approved retailer of their parts. I was unable to locate this part on your website. Does Swisco stock this part and if so, what is the cost. ... (cont.)

I have a PPG Herculite K sliding patio door installed in @ 1980. The rollers have worn to the point that it is difficult to open the door. Is there replacement rollers for this door. It is a little over 6 foor wide. If so how many are needed to replace all rollers

Hurd service told me that all their sliding doors old and new use the same rollers so is your part number 81-149 and 81-018 that you say Hurd uses for their doors the correct replements??? size/quality/fit/etc??? Thank You