Viewing all customer Discussions for:

16-023 Pan Am Take Out Clip

Would please let me know if this pictures is good for a Channel window balance, Length : 24" Inches , the code is: 23-2 =. Window was instol in 1990 , aluminum . Also I need two Pan American take out clip- plastic( in your site the code should be : 16-023). Thank you

Hello. I'm looking for the plastic cap shown in one of my pics and missing on the other. I believe this holds the balance? The balance has numbers of "26 4 NJ BS" on it if that helps. Thank you.

I ordered replacement channel balances - 19", series 377, 1840 - but have two questions: 1) Is it OK that the replacement is 1/2" longer? Exactly the same otherwise, including the number stamp. 2) How do I get the tabs on the side of both the top and foot pieces in the channel slot for them? ... (cont.)

I have a Spring Balance with stam 30 D S 40 I'm very mechanically inclined and an electrical contractor. It is 31" metal to metal The shoe (bottom) is 1/2" wide about 15/16 - 1" from curve to the front flanf and the front flange is 15/16" also The track is 9/16 to 5/8 Closer to 9/16" widetop sh ... (cont.)

I have most of the parts identified but the measurements on the bottom shoe are a tiny bit different. I included 4 images. It looks most like the 15-005 but that does not have the split like mine. My channels measure 24 and have 23 - 2 stamped on them. It looks like I need the S377-24 and a few 18-0 ... (cont.)

House was built in 1988, came with French non-tilting windows. A couple windows have balance springs (not workinig) that are fully extended (see picture)--of course this does not allow the window to say open without help of a two-by-four underneath it. Looking where the take-out clips are normal ... (cont.)

could you please help me identify this channel balance, want to replace them in all my windows, metal part is 24" long, have not measured all the other balances in my house. thank you

Hello, I have been going back & forth with Mike & Tom. Hopefully the attached images will allow you to see the replacement balances I need. The metal width is 1/2" & length is 30". I need to know if you have replacement units & for how much. Let me know if you need more info. Thanks. Jawad ... (cont.)

I moved into an apt. that had a single sash metal window that did not stay open. After a real struggle I was able to remove the window. The window measurements are as follows.The frame is 36 inches wide and 61-1/2 inches high. The removed sash is 34-1/2 inches wide and 32 inches high. There were ... (cont.)

I need help indentifing this sash. I have several to replace basicly going behind someone. This is stamped A 303. this has a small tabs on both the top and bottom looks to be approx 1/8th in. tabs. The take out clips are plastic also included to pics on this. also the the

can you tell me how to remove old clips so that I can install new ones (16-023)?