Viewing all customer Discussions for:

82-043 Andersen Tribeca Thumb Latch Replacement

there is a small marking of the word target on the lock.

I have an 8' sliding glass door from an unknown manufacturer. The attached picture show the inside handle and the inside lock above it. I would like to replace the 'inside only' lock to a keyed lock that could be used from the outside. As an alrenative, a keyed could be added above this. Do you have ... (cont.)

Hi! Last night, the door lock latch (not sure what it's called) broke off of the door lock part of our sliding glass door. I attached several pictures (sorry for any repeats!) of the door parts (lock and handle) and then the part that broke off. The part that broke off is approximately 2.75" long an ... (cont.)

Not sure if it's a norrowline, having a hard time finding this part!!!!!!! Need the hole locking assembly!!!!!!! Thanks Sean

Hi I need both parts. The latch is 3 1/8 in total height with screw spacing 2 5/8 center to center. The catch has the number 7700-16. Both are about 1995 vintage. Can you help?

I need the thumb latchforthe slinding door. The door lock appears to be working well and I am pretty sure it is a Mortise Lock Round face, Product code: 82-063 But I don'tknow which one is the correct latch replacement for it.

Handle for the lock snapped

I need to replace two of our thumb latches. The "thumb" part is extremely loose on one door and loose and no longer latches on the other. The part # 82-049 looks identical but I am measuring 3 1/8" top to bottom and 2 1/2" screw to screw. (A little smaller than the shown measurement) I don't know wh ... (cont.)

Hi the number on the back of the thumb latch I have is s2573553 I think the replacement part number I need is 82-043. I would like to replace the key and cylinder for the lock. Which one would work with the thumb latch?

Will 82-316 work for lock replacement on 200 series sliding door that was bought and installed in 1987. And, if it will, will the thumb latch need to be replaced in order to work with this keyed lock? Thank you.

Just the thumb latch broke the plate is fine

The measurements of the lock on the front side of door frame: 5-3/8"L X 1"W The measurements of the lock on the front side of door itself: 4-1/2"L X 5/8"W The measurements of the latch cover: 3-1/8"L X 1"W The initials on the lock show A/W, I don't know if that helps or not. I didn't take an ac ... (cont.)

Handle and lock broke looks like an AW

Do i need the inner lock or the latch? john

I am looking for a replacement latch for the attached pictures. Please let me know which model is appropriate. It is about 4 inches long 1 inch wide at the widest point and about 2 1/2 inches between the screw holes.

Our handle to the lock shown here broke off. Where can i order a replacement?

trying to find adjustable thumb latch keeper for anderson tribeca latch fits in door jam

1. What mortise lock do I have? 2. Can my brass latch be replaced with 82-043, White? 3. Can my brass (82-319?) lock be replaced with 82-317, white?

Need a door lock and handle for my pato door

lock is 4" long and 2.5" between center of screw holes