Viewing all customer Discussions for:

S380-27 27" Series 380 Channel Balance

Hello,Looking for the part number for a Milgard window balance from 2003-2004.Please see attached photos.The bar appears to be 27 inches.Thank you,Rod

window weighs approx 16 lbs.The wings are just shy of 1in.the inside track width where spring resides is 9/16.from your site it look like s385.the metal length is 27 in.please help windows presently has no tracks as they were damaged as you can see from picture.thanksjay

27"long 1/2" wide Stamp is 26C USB I need 2 units. I am not sure is the mfg. no stickers on the windows. The house was built 20 years ago.

I didn't find any names, but the image with numbers hopefully provide what is needed. The last ones I purchased from you were perfect. These channels measured 28" long. I also need two replacement locks. I think you carry these too?Your help in so appreciated! ??Bonnie

We have two windows that need new channel balances and side release clips for two of our windows. We have contacted a local window person that was going to come out 3 days ago and left messages but no one has called us back or shown up. Can you tell us where we can get these channel balances local ... (cont.)

The channels 27 in Long both ends are winged everything else is in the pictures one side of the channel is half inch and the other side it's open because it's got little tiny lips on them they're 9/16 so I don't know what side you would measure for that thank you

need help identifying this balance

purchased balances from your company that did not work out I may need customs

Hi, As attached in the screenshot, the channel balancer reads "26 5 JW CMC 7". Could you please help me identify the replacement part? Thank you.

Need replacement channel balance. Not sure which one to order. Can you help. Hope pics help. Thanks. Kate

Need replacement for this balancer. I don't think they are the original Milgard balancers. Metal channel is 27" long and the plastic ends are as in the photos. The window sash weighs ~19 pounds. Please advise. Thanks.

OK- I need to try this again. I thought I ordered the correct part without sending you pictures but I did not. Let's try again. The metal channel is 27 inches long and the ends are as shown in the photos. The metal channel is stamped 2620. I ordered S370-27 but the ends are not as shown in these p ... (cont.)

Length: 27 inches No stamp, but LH balance has 26 6 GV CMC 2 printed on it RH balance has 26 6 FV CMC 2 printed on it Milguard windows, original to house built in 2000 Need 1 LH and 1 Rh balance.

I need 4 of the 22-4, and 2 of the 26-3. Please let me know what products I need to order.

Length of balance is 27 1/16", not sure who made the windows, they were installed when the house was built in 1996.I need four of these, thank you! George

Can you please give me a model number for this piece

need to replace balance in non tilt window, tried going through different company but found balances the had were not correct, were tied to retaining hook instead of crimped, causing retaining hook to catch and then snappedwidest part of channel is 5/8 inmetal length is 27 in marking on metal is 26 ... (cont.)

I believe it comes from a Milgard non-tilting double-pane window.The stamp on the balance says "26 4 HV CMC 7".The length of the metal balance body excluding the plastic fittings is 27 inches.Regards,--Ivan

Need to replace milgard balancer Stamp 26 4 JV CMC 7 Metal 27inch

Hello, I am in need of a spring balancer. The only writing on the balancer is - 26 -4 JN5 CMC 8. I am really hoping this helps you?Thank You,Patrick