Viewing all customer Discussions for:

S390-27 27" Series 390 Channel Balance

I am trying to find the correct replacement.

Need to replace both Sash balances for non tilting window sash. I need the right part. Thanks

Hi.... Metal is 27 inches 28 with the ends... 1/2 inch wide. Has hook on the end.

I use up to 80 of these a year. The manufacturer I used before went out of business and I need to buy more of these balancers.

27" metal channel 1/2" width block and tackle no part no. need replacement for lower double hung window 27"x 30"

If you need more pictures I have them. Also there appears to be a very faint stamping that I believe says 26c

Appears to be 1/2" thick. metal to metal 27" long. Total letting 28"

I don't know what series it is? I just know it is 27"

Hi, I'm looking to replace four balance pieces. They measure 27" from the metal and have the marking of 2640, BSI, and VT. I included pictures that hopefully show enough to see the distance of the holes where the balance installs into. Let me know any other info you need. Thank you! ... (cont.)

Hi, I need 12 qty above window slider

The channel balance is roughly 27 inches without the end caps. Has 26 2 ft cmc 2 stamped on it. Roughly 5/8 wide

Can you please help me with correct balancer.

27" is the length of the metal Chanel. It is stamped with 2630. If you need better photos I'll have to remove it again for more info. Thanks

I'm 50/50 if it's a 351 or a 390 model. The flanges are pretty worn, but it's less than 1 1/8 but a little over 1. 2630 bs/ap is stamped. I need to order bulk and didn't want to waste the 20 bucks in shipping and returning if I get the wrong one.

We are looking to get 4 replacement rails that match the spec in the photos above. Measurements of the metal rail = 27", W = 1/2"Thanks, Brian

Looking for these window balances, marked 26-5 BA CMC 11. Will be ordering 10 of them.

I need to replace window balances on my 80's aluminum, single hung windows. I pulled the broken one out, which is also missing the shoes, and measured it. The metal is 27" long and it's 1/2" wide. It has 26 c engraved on it. Any help figuring out which balance and shoes I need would be very helpful. ... (cont.)

And need 2 window mounts with two screws. the part is 2 1/4" long

Number on balast 26. 6

These are for Milgard windows from 1989