Viewing all customer Discussions for:

21-156 5/16" Push Nut

Moved into a house with 4 sets of Fenstra bifold doors from the 60s or 70s. A number of the parts appear to be replaced a bit haphazardly. I believe I need part 21-019 for the bottoms, but I also need the bracket to secure them. Wanted to confirm. I've attached a photo of a top pivot pin that rece ... (cont.)

Accordion door hinge

I have two top pins, and 2 bottom pins missing

Looking for metal door parts

I need, I believe barrel Springs, plastic clips, I need plasticcaps I'm missing the rod, plastic holding clips, I definitely need help with this project.

Good afternoon looking to get top and bottom bushings and pins for my fenestra bi fold doors tops are 1/4" diameter by 4 inch length with spring and push nuts. Bottom pivots are 1/4" diameter and 4" length and screw adjustable bushing that slides into track needs to be 3/8" thanks for your time ... (cont.)

here is my problem. i have 40 year old metal bi-fold doors in all the closets. they are bolted together so they swing open like a regular door, so i don't use the pins on the mating edge of the doors, only the outside edge. on one door only, i can use the slot on the bottom pin and raise the door ... (cont.)

I have old metal bifold doors and I can't find parts for them. Wondering if you guys carry them, there are a lot of options on your website.

Hello, I need some hardware for some Fenestra metal bifold doors. They are interior closet doors that were probably installed in the 1960's. We have quite a few of them in a small apartment building. I'm hoping that you can identify the parts from my photos. I'd like to replace the hardware in one s ... (cont.)

plastic guide runners are broken on top track and bottom track, do you carry?

I need the push nut for an Andersen exterior door lock

I was considering replacing my clunky pin assembly as you recommend but the hole for the clamp is not square. Is that a problem? Also, the pivot clamp needs replacing but I don't see an exact match. Photos attached. Thanks!

My name is MonicaLooking for this bi fold door pin

I need a pivot pin replacement since the spring is missing. I have included a photo of the inoperable pin and one that is working. It appears the spring is missing as well as the retaining washer. I have also included a photo of all the markings on the door. Thanks.

SWISCO: I'm looking for replacement part(s), assemblies for my original Fenestra metal bi-fold closet doors. The doors are originals from when my Grandparents had the home built in the late 1960s. I need part recommendations for both upper/bottom pivot assemblies, including all pin caps & push nuts ... (cont.)

House built in 50's. Caliper measures 1/4" on cap. So product code 21-018 seems to fit all measurements. Cap on this product says 9/32. Then I also need the top guide pin but the cap appears to be wider. First picture is guide pin. I have looked for a month and I finally found your company! Please h ... (cont.)

Hi, Here are the dimensions for the pins that we need. They are 4' long, the top part of the shaft has a 3/16" diameter, the lower part of the shaft has a 3/8" diameter. The metal dome on bottom has a 7/8" diameter. The top plastic part has a 3/4" diameter. Photos attached.

I need help with parts for this door.

Hello, I need the top pivoting side of a leigh full-vu bifold door. I dont have the original one i am wanting to replace, though i believe the hole is 5/16th

I am looking to purchase your 21-105. However all the springs you offer online are either too big or too small the 2 closest ones I was able to see is products 21-151 and 21-156. If you could please offer some insight on which springs would fit best with this pin cap, that would greatly be appreciat ... (cont.)