Viewing all customer Discussions for:

26-336 Pivot Bar, Simonton

Need to identify Has a 6 on under side and 0617 on opposite side in a circle. No available info on window. Believe the pin needs to be 3" and tapered at the end to fit into shoe. Any info is greatly appreciated. Thank you.

This is window part removed

I am reaching out because I am in need of coil balance shoes for a double hung Simonton window. Both shoes have cracked and the sash will no longer stay in place. Attached are pictures of the coil and the order sticker for the window. Please let me know if any other information is needed ... (cont.)

We are looking for this pivot bar. Please let me know if you need anything further from me.

I am replacing the balances, and was hoping you can identify the part I need

Hi I'm looking for this pin that holds the sliding part of the simonton window. window type pdf is also attached thanks

Hi. I am Cesar. I would like to know if you have this kind of pívot bars.

Need plastic holder and metal part that clamps onto pin on window

Looking for this

I need help identifying which replacement pivot bar I need. I have attached photos of a good one. It is 2 inches long and 5/8 inch wide. Any help is appreciated as I didn't see it when I browsed your site.ThanksNeal

I need the pivot bar that was broken off the bottom of both sides of my window. It looks similar to this, but with a different end treatment. https://www.swisco.com/Simonton-Pivot-Bar/pd/Tilt-Window-Replacement-Sash-Pivot-Bars/26-336 Also, my spring saddle part and barrel part is broken. the wind ... (cont.)

The only identifier, after removing the hardware, is #5.5 37 inchs PAT 5232208 on the coil. I need all the proper hardware to replace all coil balances on both sides of the window, the pivot shoes, and coil supports. not sure if this setup is considered single coil, double coil, or more. Note that ... (cont.)

Hello, I'm looking to find the pin that best matched the window that was installed in '09. It's a duel window system thank you.

The pivot bar fit great in the window...but I'm noticing now that it doesn't fit in the shoe correctly since it is a different shape than the simonton original pivot bar (there is a ridge before the end). It essentially creates a gap between the window at the casing when the pivot bar is going into ... (cont.)

Hi could you identify the replacement for the pivot bar pictured in photos. It may be from Certaiteed or Simonton. has 2 numbers stamped, o3 on bottom, 11 on top; 2 holes, 2-5/8" long. The pivot housing is original, see picture (metal, slightly oval. Thanks, Don

Help, Please!I ordered pivot bars to go with the new shoes, but the pivot bars don't fit my windows and I can't even remove the old pivot bars from the windows.The first three pictures are of my window's pivot bar. I removed the screw, but the pivot won't come out and the new ones I ordered 26-125 ... (cont.)

Side mounted spring loaded rolled steel ribbon tensioners for an impact window Manufacturer unknown

This one was broken off and you can just see half the screw hole,thanks in advance for your time!!

Thank you

manufacturer number for coils are 405s and 406l and also need to replace pivot bar and pivot shoe