Viewing all customer Discussions for:

26-337 Top Tilt Latch Pair, 2", 13/16"

I need the locking mechanism and side latches (both pictures above) for Ellison validator series 200 windows. Could you please point me to the appropriate parts? Thanks, Rob

This is the part that lets you swing out the window to wash the opposite side. Would you have these and the cost?? Thank you. I gave you the wrong email on the previous part finder.

Okay so I'm trying to locate several parts for the old us window factory till Windows the latches I only put in one picture because it's kind of self-explanatory I get left four pictures of what's left of the springs so I'm not sure what part that is I don't really see a pivot shoe cuz it's down on ... (cont.)

Looking forward replacement tilt window latches

Looking for the correct replacement tilt latches based on the measurements in picture.The screw holes are 2 inches apart and the depth is correct at 5/16th. The latch, per my new pictures is 2 and 7/8 long and 3/4 wide. The underside does have a curved end (see picture of underside). ... (cont.)

Beige plastic/vinyl 2 in between screws

I don't see any information on my part. I have only the dimensions shown in the pictures. I would like to get a quote on a dozen pairs

can you help locate a latch like this?

Hi, We have 6 GA Windows, white, Single hung, tilt sash needing these parts: 6) each Tilt sash latch, R & L (12 total) top 2 screw holes are 2" center to center. 12) Shoe, for TS Balance, White 12) spiral 3/8" TS Balance, 33"

These latches are off of a 25 year old window with no identification. They are almond,and measure 1"x 3" and 5/16" tall. Screw holes are at 2" centers.

The tilt latches on one of my windows recently broke so I'm searching for a replacement, but having a hard time finding the right match. Dimensions: 3 & 1/16" long (not including extended latch) 1 & 1/8" wide 1/4" tall 2" gap between screw holes All of my windows use this latch model and the house ... (cont.)

Snapped off the latch part and need replacement. 2 inch apart screws

Would like replacement tilt window latches shown above for GA windows

I need to order a few of these window locks. Please let me know what the part is. Thanks

Purchased 26-120 and 26-121, believing these were the correct replacements but they do not fit. The picture shows the purchased item (top) versus the original (bottom). Almost a perfect fit but the purchased item insert is larger and the length is slightly smaller. My order number is 2172516. I'd li ... (cont.)

we need the tilt latch that works with the 40638 swisco part.

No marking. Got the window from Thermosash. They said they have no idea how to get replacement parts. A few years ago I got the part I needed from you. It fit perfectly and I'd like that same part again, for a different window. I can't afford new windows and I'd never buy anything from Thermosas ... (cont.)

i found the spiral balance part but not sure which shoe plate and latch i should select. please help

I need to replace broken springs for MI window. The window was replaced around 2008.

Trying to identify the make/model of this window tilt latch. It doesn't appear to have any discernible part number on it.