Viewing all customer Discussions for:

39-152 Andersen Classic Operator Cover

Works out except just before closing. Numbers visable in photo. Removal looks hard, no need as in movie, but wood on top looks glued along length.

We have a bay window with a casement window that does not work very well. I'd like to replace it. I do not know the maker of the hardware though or that of the bay window. How would I find out what part to get to replace the operator with? Currently, when cranking the operator, the gears do not ... (cont.)

Is your product 39-264 to replace Anderson F-9400-3A?If yes, pls confirm the price.Anderson F-9400-8A front and back imagesTHANKS.Best regards, PAUL

I am looking for closing mechanisms for two Anderson Windows coded CXW135 when I bought them in 2007. I have attached a photo of the mechanism in question. There is a part number on the window 0603094 and PROD ID 123-07103-99348.Can you help me?Kyle

Need help with a replacement.

F-9400-8A window,this is the one i need?can i send the other one back?

the opener is from an Anderson Window. From the rivot on the end of the arm to the center of where the arm meets the mounting bracket is 14". The base is 5 3/8" wide. It has the following numbers on the top of the arm: 1 361 485 R & 1 361 482 HOP It has the following numbers on the underside of t ... (cont.)

Need a new opener unit. Internal mechanical parts seem all wallrd out. 16 inch arm Anderson opener. I'll also need any required hardware to replace. Thanks!

c-9400-1 (front) f-9400-8 b (back) the window is on the right side and opens to the right

These were installed around 1986 when units were built.. I have 3 wood windows, all on right side with lock to left of the handle?when you open, they don't catch as you turn crank so it takes awhile to fully open. Didn't want to completely remove since I needed to close window afterwards? These were ... (cont.)

These numbers are on the arm 1361460 07/16/02/1 Also measurements of the arms are 3 1/2 and 4 1/4 Thanks!

Would this work as a replacement for an Andersen Classic Series Operator for casement windows? I need something that is low profile to work better with window blinds

hi - this window was damaged by a bear getting in. looks like i'll need that bent arm assembly, as well as the crank and cover for the latching mechanism. also some of the wood trim parts and the screen. thanks for your help!

I need the cover and the handle and white and in any other color y'all have

I am attaching two pictures below. Hoping for some help identifying the correct parts. Thank you in advance!

I need to replace this operator

i believe these are the original windows and the house was built in the early 80s near sacramento california. the interiors are wood and the exterior seems to be clad with vinyl. i will be so appreciative if you can help me find the handle and other parts! thanks.

I have older Anderson window, and am looking for your truth folding handle with cover for an older Anderson window ;the size I need which is approximately 3.5 inches wide . Do you have them? I am attaching a photo

Pics of the faulty part in question. On the top, there is a Part Number of F-9400-A by the center circle. On the bottom, there is a marking of 1361484 and 052402 on the second swing arm. I presume the 052402 is the manufacturer or inspection date since we purchased the Anderson encasement windows in ... (cont.)

The photo shows my existing operator has three screws aligned with the geared pivot point plus two more screws on a smaller centerline toward the external side of the window. All replacement operators I see have a different mounting screw arrangement with two unaligned mounting screws with smaller ... (cont.)