Viewing all customer Discussions for:

26-344 Top Tilt Latch Pair, 2", 3/4"

11.15.17 Thank you for the balances you sent for my window repairs. Finally got everything working. Two of the latches have broken plastic pieces on the end of the latches that hold the window in. This is a double window and one is a left and one is on the right. The warranty number on ... (cont.)

Part inquiry # 7515069 From Frank

I am looking to replace hardware on my windows. On the inside of the glass, there is a stamped number that reads INE-89. They are tilt-in windows made of vinyl. Any help would be appreciated. Don

See the enclosed photo. My latch is 3" x 1", the first hole is 3/4" from the end of the latch. We bought the house new in 1993.

i ordered 2 replacement latches from you in May 2017, you sent me 26-158/26-157. they dont fit please let me know what part is needed, i need right and left top tilt latches

I think one of these is part # 26-344.. Not sure about the locking one though... Any help?

Unfortunately, there are no names, numbers or markings shown on my windows. So, I do not know the manufacturer. I thought they were made by Harvey Building Products but HBP said no. I do know that the windows are double hung and I need several replacement window locks and sash releases as shown in t ... (cont.)

Need 3 lefts 1 right

Hello, My grandson needs me to fix a window in an apartment he owns. So, it is approximately 3 inches long, 1 inch wide, and has 2 inches between holes. The window is functional, but seems to have been forced to fit since the lock is bent so that it reaches the length. Please review the attache ... (cont.)

I am looking to buy Windows Tilt latch for the right and left sides. I would like to buy 20 pieces. Please, review the attached photo and measurements. Thank you for you help.

I need to replace the Tilt latches on the bottom window. The measurements are 1 inches by 3 Inches with two inches between the screws on Center. The depth is 3/8 inch. The measurement across the outer edges of the screws is 2 5/16 inches

The lock is White, approximately 3.5" long, a little over an inch wide and the screws are 2" apart in center. The lock is flush mount and all plastic.

Bought this house with replacement windows installed some time ago. I Bought the broken latch using Part # F2598. As you look at the window on the right side a plastic part is broken. While washing the window the top fell off the track and broke a white plastic part. The left side of the window has ... (cont.)

2 7/8 long 1in. wide 1 3/4 between screws 1/8 thick I have had great luck with you with the pivot rods for these windows hope you can help.Thanks, Tom

I cant seem to find one that matches exactly. one I need is similar to 26-344 but my is 1/18 wide and opening is round not square. would this one work or would something else work better. thanks Clyde

Can you identify the tilt latch whose picture is attached? Tks

I can't find this part. I believe the windows are Jen Weld but not positive. CAn you please advise. Thank you Dan

Hi, Thanks so much for your videos, they are very helpful. We need to replace: Pivot shoe measuring 1 1/4" wide, 17/32" deep, 2" tall (we believe the part # is 15-015 but not completely positive. Left side top latch 3 1/2 L x 1 1/16 "w Our sash stop is only about 1 inch long as you can see ... (cont.)

Can you help me identify this tilt latch?

this latch measures 2" between holes. I could not find one on your site. What do I do now?