Viewing all customer Discussions for:

33-085 #6 x 3/8" Pan Head Tek Screw

Dear Sirs I have installed the Swisco 84-016 Roller. Unfortunately the roller does not attach to the "notch" to hold the roller in place. (I believe the two pins on the "notch" have broken off (see the photos). How do I remove the adjustment piece from the door which includes the 2 pins? What r ... (cont.)

I'm looking for the plastic bracket above that the screw screws intot to keep corner attached do you know if you have this peice? Thank you like always, Brian

I need help making sure I order the correct ones from your site. One of the corners has a stop on it.

Can you determine a replacement part you carry by the pictures provided? Thank you

PGT sliding screen door. Replacing rollers Need small white plastic piece that holds/secures corner screw Photos included

Hi, the top part of the corner goes into a standard 3/4" screen frame that has a 1/4" thick opening. The bottom part of the corner goes into a different size frame. The best way for me to describe the bottom part is that the frame has an opening of 3/16" by slightly larger than 1/2". ... (cont.)

Year 1960, Model D-ALWINTITEThe springs I have measure 2 inches shorter than the window measurements. I need:53 inch window Quantity 1645 inch window Quantity 1233 inch window Quantity 1037 inch window Quantity 2Please me know if these are parts that you carry along with price an availability. If mo ... (cont.)

I am looking for replacement rubber sweeps for these approximately 30 year old Pella French Storm doors in the pictures. The metal holding the sweep is approx 7/8" wide and the rubber is approx 3/8" wide, making the total installed sweep width approx 1-1/4" and a length of 27" for each door sweep. ... (cont.)

Hello, we need new screen door panel retainer strip/trimming for our Sears best - storm door 948.65103272. The old I am hoping that you carry them. Thank you, Melvin

To whom it may concern. Attached are a few pictures of a spiral balance I am having difficulty locating. Parts a from a fairly old (1950s ish ?) single pane double hung aluminum window. Any help would be much appreciated. Thanks, Luke

Do you drill these plastic style sliding screen door corners out like you would a metal one? They are staked twice. Also, where do I find replacements as the sliding screen door frame does not go together flush and standard replacements would effect the door fit and operation?

I work at a mid century modern house that is a bed and breakfast. The house was built in 1948 and has Alwintite windows throughout. I am looking to replace some of the sash springs. I attached a couple of pictures of one I removed because it came out through the bottom of the sash. Since I ... (cont.)

need to stop air from coming under door. What do you suggest?

I believe I am missing the bracket that the spiral balance locks into under the sash. They are non tilting metal windows. The spiral balance matches closely to the 5/8 in 500 series with the small butterfly clip at the bottom. i tried to capture the underside where I think the bracket should go. ... (cont.)

the door is a part # 400clm it's a wood core steel door. this is a picture of the bottom sweep it's 1 3/4" wide the closed sweep is the inside part of the weather strip this is a stick on sweep there is no track on the bottom of the door that is slides in to. it's a 36" door. Please help winter is ... (cont.)

I have spiral balances in my home. They match your s400 series of spiral balances, but I don't know what clips to use for the bottom.

Hi, The house was built in 1954 and a brand name on the window says "C-Alwintite". One picture shows a spring which I cut to remove it, so a square shaped metal plug attached to the spiral that wedged into the bottom of the sash. It was near impossible to re-insert the plug once it came out the ... (cont.)