Viewing all customer Discussions for:

S385-30 30" Series 385 Channel Balance

Could you find the correct channel balance for my window?

I need 2 of them .. one for each side

The plastic ends on my guide looks a little different from the ones y'all have and wanted to make sure it fit. The metal channel is 30 inches. The plastic base also is exactly an inch wide if that helps. no major stamping other than the printed numbers in the pictures.

I am looking to purchase top sash guides and balancers. The metal on the balancer is 30" long. There is a stamp on the balancer that says 29 3 BSI ML thanks!

Channel Balancers needed. Thanks

30' length 29-3 stamped on metal

Stamped with 29 9 JM CMC 11

30" long of metal Non Tilt Windows

Imprinted number 2930 on rail

Measurement of the metal only is 30 inches long but there's a stamp on the side that says 29?

29 3 DN Caldwell Metal bar length is 30"

I need to replace all of my balancers. These two are from two different windows. They are the same length and width but notice the spring is loaded in a different position. One window is 47" and the other on 50". Based on measurements your recommendation is the 30" balancer. Please advice is this ma ... (cont.)

It is a non-tilt, Milgard window, 30 inches tall, half inch width and 5/8th inch depth, I sent 5 pictures with the stamp too. Please let me know if you need more information.

Hi. Do you carry this product? The markings are 29 9 AJT CMC 2.

Hi I need this part for 6 windows please

Hi, can you help identify what part to order? the bottom part is 1 1/32 Thank you.

The channel is 30" metal only. The sash weight is 17lbs. The width is 7/8"

I need replacement pairs of window balances for the balance shown in the attached pics. The numbers 2930 appear on the balance (see pics). The overall length is 31 inches including the white plastic guides. Approximately 1/2 inch (13mm) in width at the metal body. These balances are for a single hun ... (cont.)

Non tilting window, very difficult to open and close. Replaced two broken 18-127 parts. Want to see if replacing the channel balances solves the issue. Are you able to identify the correct channel balances I need from the pictures.

I have two Lawson Industries LI-613 Series SH-7500 aluminum single hung windows which need replacement channel balancers. The windows are 36" wide by 62" height. The bottom pane weighs 14 pounds. The channel balancers are 1/2" wide and have the following identifiers: 2920 NL BSI. ... (cont.)