Viewing all customer Discussions for:

S385-30 30" Series 385 Channel Balance

Need two 33" Channel Balance for window. The numbers on the channel balance read: 32 3 IW CMC 11. I measure 33" from top to bottom of the metal. I also gave a photo of the window edge for additional help.

I need the complete balancer set for a Simonton window.

Hello, I have several channel balances that need to be replaced. All the windows are of the same non-tilt design. The balance that I have is 30" long and stamped with 29 4 DT CMC 4. Attached are the pictures of the bottom and the top. Thank you very much, Vladimir

30 lnch length. Broken

I need to replace qty. 2, block & tackle assemblies, complete and ready to install. Channel Length = 30, Width = 1/2". Stamped on the bottom of the channel is: 2930 CA in the vertical and in the horizontal small stamping B S T. Any support will be appreciated.

Need help identifying series to order. Current is a BSI 2920. Please see attached for photos. Thank you

Need 2 balancers 30" - see pictures attached Mark 40/50 SH FIN H-LC35* 120x77 (mull)

Need replacement parts. Not sure what number I need to order.

29 4 BSI These are the markings in the patt

Hi . I have some kinco windows that have seen some better days. The plastic clip that holds balance rod in place is broke on many windows and same with a few clips on balances them selves the metal rod is 30" and 1/2" wide. Here's some photos I believe I found the parts I need on your site but I wou ... (cont.)

I'm looking to find a replacement for my window balancer. I have a handful I need to replace so I don't have all of the sizes/markings yet, but I wanted to start with this one so I can buy two. Thank you. Markings: 86 29-4 FC5 CMC 08 Channel Length = 30"

hello, Need to but window balance spring, it printed on old channel as follow 28 9 CX CMC 7 , Non tilted glass window. I want ot know if not fit properly , can i return it ? Suggest me , need 6 of this ? it is available local in fort myers ? or only online Thanks

Need replacement for right and left side, Lawson window, 30 inch channel

Stamped on the channel balance: IMP 29D s 38 (symbol) CQ Just the metal housing is 30 1/16 in long, and 5/8 in wide

There's a stamp "29 5 LW CMC". Metal channel length is 30". Width is 1/2". I tried my best to get an accurate measurement of the bottom shoe and it appears to be 1-3/32" but hard to be certain. Hope I provided enough details. Thanks in advance

What part do I need to replace my window balancers? Window measure approx 46x66

I would like to identify the replacement window channel balance and top sash guide needed. The channel balance is 30", non-tilt window. The balance has 2930 stamped.

NEED CHANNEL BALANCES THAT SHOWS A DESCRIPCION BUT I WAS UNABLE TO FIND THE PART NUMBER. ALSO NEED THE TOP SASH GUIDE PN 18-188 AND A SMALL CLIP BELOW ON THE PICTURE.

2 vertical sliding windows in my home have these parts break and I'm looking to replace them. One I believe says 29-5 while the other 32-9.

29-5 HA2 CMC 24 Believed to be 1/2 in