Viewing all customer Discussions for:

39-366 9-1/2" Single Arm Operator, SS Roller

I am looking for replacement cranks. My house was built in the mid 50s. They are stripped and won't close all the way.

Can you please help and identifying this part please! Thank you!

The (3) images show my original Anderson operator, and specifically the arm offset (dropping-down by about 3 mm). I bought from Swisco your part # 39-027E which would be adequate, except it does not have the arm offset of my original Andersen model. Swisco operator part # 39365 would likely also ... (cont.)

Looking for a replacement for this window operator. I don't see any that have an 11" arm, but I think 11" or 11 3/4" will work. Also, I don't see any with a 1/2" square nylon slide that matches mine. I think a wheel will work, but I'm not sure whether another attachment style wold work better. ... (cont.)

Hello - Our home was built in 1970. We believe that the kitchen casement window is original. It is a double casement 52" Wide X 42" High. The windows do not crank open unless we push on the glass while opening. We are looking to replace the hardware on both sides. We would like the inside levers to ... (cont.)

Greetings from E. Tennessee!We need to replace numerous Window Crank/Gear Assy.'s for our Anderson Casement windows and I would appreciate any assistance in selecting suitable replacements.I have attached numerous photos for examination.Anderson Crank/Gear Assy. # 7073B Left & RightLength of Arm ... (cont.)

I'm in need of the attached part.

I need a right and left for craft line casement windoed 2 numbers are seen 7073b. L. 30350 is on a piece too

Need some cranks for house built in 1970. Replacement ones I've gotten so far are either too narrow to fit on the sleeve or do t go all the way flush to the base. Part number 60-c-7041-62 with small 6 below. Many just need the knob but have heard can't get knobs alone. Thanks

The window to the left of this one is .missing the complete lever,, need to be replaced

Hi, I'm looking for a replacement Crank arm as well as an operator. I believe the crank arm (based on other posts) is your part number 39-286. The only identifiable part number on it is 60-C-7041-62. As for the operator, I only see the number 81 on it along with Andersen and R with an arrow. Pl ... (cont.)

replacement crank gear box 091620040423 truth windows

Gear inside mechanism must be stripped! when Opening or closing crank its a dead spot and handle turns ,but window does not move!

These casement cranks + operator look between a brass and stone color. They are original to the house built in 1970. Some are stripped, and we must replace them quickly before house closes on September 4th. Would like done before inspector looks over home. They have a logo which I'm guessing is SM C ... (cont.)

Hi,I need help with replacing the hardware on these older windows I believe from the 80's.There are 8 total but I am sending pictures of these 4. I drew the dimensions on the pictures.I can customize as much as you recomend so don't worry if yhere needs to be modifications to the wood. ... (cont.)

The mecanisme of the operator is broken. I need to replace it.

I'm looking for a left side opener for an Anderson casement window. The gear is skipping. I did not remove the wood trim, but the arm is between 10 and 11 inches long. The hardware with the crank handle is 4 inches wide. Can you help?

Need to find similar or same parts

Anderson 2420 RH can't find one

All It has marked on it is Anderson. I just need something to replace this not sure it matters the brand.