Viewing all customer Discussions for:

82-249 Sliding Glass Door Multi-Point Keeper

I replaced the Double Hook Mortise 82-238 along with the inner and outer handle. The existing Multi-point striker was not replaced, It is the 89-030. At one time, I added a flat head screw to the center hole to actuate the safety on the latch, otherwise it doesn't work properly. Is this correct? ... (cont.)

I purchased the MULTI-POINT MORTISE LOCK WITH FACE PLATE, 11", and need the keeper that goes on the door jam side. I purchased a 1/2" deep one but it is not deep enough. Which one would be best to use.

I need a keeper but i would also like to change the outside so that I have a handle to the outside. Please help. I have picked up a few keepers from lowes and none have worked.

I need keeper for this door

I have a guardian sliding glass door. I need a key lock for it. I don't know which one and what parts will fit? I need a beige one. the current handle say," Pella" but the glass says, "Guardian". looks like: Product Code: 82-086 Product Code: 82-249 Product Code: 82-265 What 3 parts numbers do I n ... (cont.)

We moved into a house over two years ago and installed a pet door in our three panel sliding doors (the middle panel is the sliding door). I removed the latching mechanism and put it somewhere "safe". cannot find it. removing pet door and need to secure door. I cannot read the label (picture on ... (cont.)

Hello, I need to replace a double latch mortise lock on my sliding glass door. I have identified your multi-point mortise latch 82-259 as the most likely replacement part. However, I am concerned the 3/4" width is far wider than my approximately 1/2" opening for the replacement part. Please see atta ... (cont.)

Hi I need the white part and the metal part inside please identify

I working on a home that had a dog door installed at the same time the door was installed. Can't find the lock plate that is attached to the frame. Need to find this part.

Lock has become jammed and wont release, causing it not to lock. What do I need to fix this? Thanks

Need replacement

Looking for the correct bracket for the locking mechanism to latch into WHILE making contact with and depressing a pin that must be depressed for locking mechanism to operate. Picture shows track with 4 holes where bracket should be installed opposite locking mechanism that is also pictured. ... (cont.)

I have an issue with my patio sliding glass door lock assembly. The top lock is remaining in the locked position and not allowing me to open the door. I need a lock similar to the 82-265, but both of my locks point downward. Do you have any other locks besides the 82-238 and the 82-265? How do I kno ... (cont.)

I couldn't find any part numbers on the piece that is broken. The top latch part doesn't go back in when unlocked and catches. My husband ordered a part from this site he thought would be a match but it isn't. Hoping we can swap them out. But need help identifying the right part. Thanks! ... (cont.)

Mortise lock: patent number 6.264.252 handle is patent number Amesbury Hardware: D466787 cover plate for side of sliding door is inset and has CS marked on it. I have photos if needed . I live in Lakewood, CO . suburb of Denver . door has a heavy metal frame that the mortise locking component a ... (cont.)

Need lock device

I ordered the swisco 82-239 on order number 1266000. But that's not the right one. What do you recommend?

I?m looking to purchase a mortise keeperPatrick

HelloCan you please help identify our sliding door lockThanks,Peter

Doors are old and don't know brand. Bought from Lowe's but they don't have replacement handlesSorry can't remove or can't open door!