Viewing all customer Discussions for:

81-158 Dual Roller Assembly, 1-1/4" Steel BB

Hello, Here is a picture of the part I need. I need 2 sets of rollers and total cost. In closed is a picture of one set thank you Michael.

I have a vinyl Pella sliding patio door. I need to replace the rollers. The product ID is difficult to read but looks like MO210047776-NFRC May 7 2003 94 Can you help with which are the appropriate replacement parts ?

I bought this door 20 years ago at Home Depot. It has become very difficult to open and close. I've cleaned and lubricated the rollers to no avail. I would like to replace them. Please help me identify the correct parts.

I have door off tracks and rollers unmounted. Can't find replacement rollers in area. Can you help me. Other than Guardian tempered glass on the glass have not found door makers name.

I purchased your 81-158 tandem roller. My old screws don't fit. What is the correct replacement screw thread count.

We just replaced the wheels with new from Home depot and it works like new. I was going to buy new tandem rollers in the event Plan A failed. But it looks like we are good.

This slider was removed from my patio door today after being installed for only 2 years. The one bearing is rusted tight. I cannot find anything on the roller or the door that identifies the maker or the part itself. I have also gone to numerous stores with no luck. Thanks in advance ... (cont.)

I need a set of replacement rollers for a sliding glass patio door. The rollers are off of a Kinco door (out of business). I took pictures and wrote down some measurements. Please let me know if there is anything else specific you need in order to identify the part. Thanks for your help!! ... (cont.)

Please tell us what rollers to order we need 2 for the door that moves Thank you Stef L

It doesn't have any number can you help identify it? Thanks

I am interested in purchasing Dual Roller Assembly, 1-1/4" Steel BB Product Code: 81-158, however the one I have has a 1.125" roller instead of the 1.25, will this fit?

Looking for a replacement part. This is a roller for a sliding glass door. Any help much appreciated.

I'm trying to locate two of the roller pictured here. I've been to Home Depot in Oregon City, OR and W.C. Winks on SE 2nd. in Portland, OR. Measurements as best I can determine: roller: 1 1/8" x 4.5/16" housing length: 3 1/8" (-) x 5/8" maximum length of housing to end of raised roller: 4 5/1 ... (cont.)

Please specify replacement tandem roller. Dimensions are 3-1/8" L x 1" H x 11/16" W with 1-1/4" diameter wheels. Photos attached.

I would just like to comment on the service I have recieved by staff at Swisco. It has been wonderful. I have not purchased much - just my home needs on my manufactured home, but without your expert staff and inventory it would have been so much more difficult and expensive. I want to thank you a ... (cont.)

I have a Weathershield 8' patio door installed before 2000. The roller looks like and matches the dimensions of your 81-087 except for the rollers which are 1 1/4. The left most hook fits into a slot and the right most is just in the void on the side channel of the door. Being that the hooks are rec ... (cont.)

Thanks for contacting us! Are you sure you have a Pella brand door? I do not believe that the 81-030 Acorn Patio Sliding Glass Door Roller can be used for Pella doors. Could I perhaps see a few pictures of your existing roller? Make sure that it's fully removed from the door before you take the pict ... (cont.)

Hi, I am looking to replace the wheel assembly for our sliding glass door made by International. Attached are photos. Can you guide us to which wheels we should use? Thank you. Todd