Viewing all customer Discussions for:

90-274 Acorn Lock and Keeper, 2-1/4"

I have American Craftsman windows that are single hung - I believe they are 50 series. There are 2 locks on every window. Do you have a replacement for these locks?

I need your help again, this time a center lock for a tilting vinyl window as pictured. The screws are 3" apart. (If the only replacement available has screws further apart, that is OK since I can drill new holes into the frame.)

Trying to find and purchase about four of these sash locks and keepers. The keeper is about 2.5" by 1/2"

Selling House, Inspector said 4 of the locks were broken and just sitting on top of lock. I've attached picture of non broken lock, and one of lock that latch is broken from and the top and bottom of the latch. I have four of these that are broken. Do you have replacement parts that I would need to ... (cont.)

Looking for a viking window lock. It is a sliding window

Window lock for picture window

Do you have any of these? - 2 1/4" between screws - 3/4" from window edge to each screw

I am looking for replacement locks for my window, it's 2 1/8 hole space on the lock and 11/16 on the backset. The backset piece needs to be flat in order to work on my window, as the thicker ones wont let the window open or close

Sorry, no pictures of the latch installed, but I think that the depth of the sash keeper is unique. 5/8" at the shoulders, 1/4" wide, 2 1/4" from screw to screw.

Hello, I can't find any identifying codes on these pieces except MDO in the middle of an imprint of Texas. I think there is also the number 5 or 6 below the MDO, but it's not super clear. I've attached the "top" and "bottom" of the two pieces I need. (I need several of each.) Anyway, I can't fi ... (cont.)

I need a replacement part for an empire window latch. It has 373 stamped inside. It is approx 2 3/4 long and 1 inch wide.

Attached is a photo of a window lock I have in my home. The windows are double hung vinyl installed in my M/I Home that was built in 2014. Four of the window locks are broken and I can't seem to find replacements. Any suggestions?Thank you,Steve

Hi I need to replace a number of windows latches they are the following Body: 8300-02 Latch: 8313 00-1 Handle: 8301 N.A. 2

I need to replace my window locks and strikes

Viking the keeper has the numbers 30220 on back

Having trouble finding a replacement part for these old viking window locks. The keeper is very thin.

Replacement for attached

Do not have manufacturer identified on windows only "compliance" sticker. Have one broken latch and would like to purchase several replacements for current and future repairs

Need help identifying a replacement part for window latch. The latch holes are 2 1/6" apart and the part it locks into the holes are 3/4" apart. Hope you can help, thank you.

I need to replace a window latch.