Viewing all customer Discussions for:

26-398 Round End Pivot Bar, 2-1/2"

BiU

Slidin Window Metal Pin which goes inside 8 lb Series 140 Quick-Tilt, Single

2.25" long, nose hole is threaded, has an offset

Hi There, I need complete set coil balance (left and right) for my window. do you mind which parts i need? appreciated

The one shown is not broken... need to find part #

We have a bay window with two series 4000 double hung (model 3B01) and both the pivot shoes broke on one of the windows. It looks similar to 15-177, but ours has a hole just above the metal shoe.Any help is appreciated.

Help me find this part please

I have about 21lb window. It says 10k on the previous coil. Also i need pivot bar

The building was built in 2016 if that helps. I hope you can help! You always do!

pat # 6983,513 & 5317971 letters A-F #10 top left corner PAT PEND

Hi. I am looking for coil balance for windows. Here are pictures. The measurements of the coil balance is11/2 inches wide by 1/5/8 inches long.Do you carry coil balances for windows? Thank you.

Hello! My pivot shoe and bar are broken. I have an Anderson window, as described on the sticker. Could you please help me with choosing a correct pivot shoe and bar?

G 10 I.

Pivot bar with A5 etched on one side?

Hi...had a failure of the rectangular white pieces that sit in the window channel. The picture is a properly functioning part (the old one was discarded unfortunately. Thanks so much!

Hello we need help identifying a replacement for these parts the window sash/channel balance (the white plastic parts inside the window), and the pivot bar to match. Please let me know if you need more photos or info!

This piece of the window is broken and I am looking to see where can I get a replacement or how I can possibly fix this issue. The window cannot open since the attachment in the second foto is broken which makes it heavy to pull up or down.

Hello, I am needing to repair a single hung window, company is Renaissance. I have tried contacting them directly but get no response. Desperatly needing to replace the metal shoe part on the window balance. Requiring both right and left side, guessing this part is the same on both. The dimater of t ... (cont.)

Hello,I am attempting to satisfy a customers broken sash. Would you please help identifying the replacement parts required? There are a lot more parts required for this project, but this is the one I'm having trouble shooting.Regards,Danny

It either 2 15/16 long has number 5 on side foist hole from curver end is 7/8 and second hole is at 1 1/2 from curved end