Viewing all customer Discussions for:

26-122 Vent Latch

I'm trying to replace these safety latches with either just a flat piece that fills the hole or a safety latch that I can keep flat unless I want to push on. Rough measurements of the hole are 2 3/8x 1/4"

Is there a replacement part for this window security latch. It measures 3". Mighton PCT/GB09/1526 13/04/12

Can you help. Rich

I need 3 left and 3 right tilt-in clips. Can you match these from the photo? I also need 2 of the lift clips. I included the photo of the lock for reference only.

Andersen SilverLine 3000 Replacement Vent Latches. i need around 12

Hello we have 2 large Midgard windows that need all new bakancers and shoes, 3 springs each at 9lbs we were told. 1 window needs a new tilt and pivot bar. We watched the video and don't want to cut the vinyl to remove and install the new balancers is there a special tool that can spread the chan ... (cont.)

Looking for assistance with three broken window pieces 1. The first (picture titled window 8) screwed into picture titled window 4. There were two that broke and the top part of the window came crashing down when opening. 2. The second piece (picture titled window 7) came from the bottle inside ... (cont.)

I need the rollers for the bottom of the window I need the roller platform that the window sits on In need the vent lock The window is made by simonton

I'm trying to identify the tilt and vent latches on my windows. There are no markings. I measured the tilt latch slot to be 9/16" x 2 9/16" and the vent latch slot 1/4"x1 7/8". Again, the measurements are of the routed slots or cut outs in the window. Thank you

#1 is the top latch #2 is the limiter (can't open the bottom window past that point)

Looking for replacement, white

Please email me to let me know if you have these partsDavid

Looking for plastic piece built into a double-hung window that can lay flush with the window sash or you can manually press on to extend out. The purpose is to limit the height that you are able to lift the bottom window sash. These plastic pieces have broken off on a few of my windows and I am look ... (cont.)

Need replacements (2)

I need an astragal white plastic part for my NFRC 100/200 window. Do u sell this part.

The stock vent stops that were in my Harvey windows cannot be "locked" in closed position, so must be removed to open window wide. Looks like your stops have a slide that allows them to be "locked" in a closed position. That would allow me to leave the vent stops in year-round (don't want to leave s ... (cont.)

Looking for a latch for this window, unsure of make or name? All of them busted out.

i need replacements and also ask if there is anything stronger to swap out with this one fir a first floor window

White window stops for EPI vinyl windows. Each part measures: 2" long x 3/8" wide x 9/16" deep The model number (from Cascade Windows in 2017): 30963 Numbers on the parts themselves: 44 on one side and B on the other These parts are no longer made by EPI or Cascade Windows, who referred me to yo ... (cont.)

Hello, We need to replace our white sash vent from an Empire Pacific window. The second photo shows it before it was removed. If you look closely at the silver strip behind the sash vent you can see it is an Empire Pacific window. The first photo is of the sash vent after we pulled it out. o ... (cont.)