Viewing all customer Discussions for:

90-278 Lock & Keeper, 2-1/16"

Original windows on the 5 y/o home we just moved into has plastic locks, and the levers break easily. Need metal replacements.

Looking for parts. I bought a set of Jeldwen white Vinyl windows from Home Depot in 2003. The wen locks/keepers and the (weak) "security locking pin" assembly (plastic tab to allow window to open only 3") all need replacing. The stationary parts are both 2.25" (pair of screws on centre), and the w ... (cont.)

Hello, I can't find any identifying codes on these pieces except MDO in the middle of an imprint of Texas. I think there is also the number 5 or 6 below the MDO, but it's not super clear. I've attached the "top" and "bottom" of the two pieces I need. (I need several of each.) Anyway, I can't fi ... (cont.)

I need a replacement part for an empire window latch. It has 373 stamped inside. It is approx 2 3/4 long and 1 inch wide.

I need to replace both the locks and the keepers for Advanced Window Corp windows. The holes on the keepers are 2-1/4" apart. The holes on the locks are 2-1/16" apart. Please see pictures for additional dimensions. Thank you!!

Hi, I would like to order Viking Window Lock as per picture. Please advise me what I can do. Thanks.

Need two complete units. Not sure if you have them in beige like the ones I have but I can use white if not.

All markings are shown on my photos.

I am looking for a sash lock-mounting holes are 2 1/16 and offset is 11/16. It is die cast white. Thanks Alex

I need to replace some sash locks in my home and can't figure out what I need. I saw one that looked like it would fit but wasn't sure. I also need wool pile for one of my windows and I didn't want to cut it out before I had a replacement. It doesn't slide right out so ai'm assuming I'm gonna have t ... (cont.)

I need two Viking replacement window latches. The number found on the latch is 8300. The number on the metal narrow lock is 8315.1. The color is beige or tan.

Attached is a photo of a window lock I have in my home. The windows are double hung vinyl installed in my M/I Home that was built in 2014. Four of the window locks are broken and I can't seem to find replacements. Any suggestions?Thank you,Steve

Hi I need to replace a number of windows latches they are the following Body: 8300-02 Latch: 8313 00-1 Handle: 8301 N.A. 2

Looking for this part

I need to replace my window locks and strikes

Hi, I'm looking for a replacement for this lock. One of my windows is missing pieces to the lock. The center to center measurements for the screws horizontally is 2". From the screw on the latch side to the end of that piece is 3/4".

Viking the keeper has the numbers 30220 on back

We have an 8 year old house with SIlverline Windows (#8002344228). The lock handle snapped off the pivot point and I need another lock. The holes are 2 1/16" apart on the main body and the set back is 11/16". The problem I'm having is finding a catch that is 1/4" deep.

Having trouble finding a replacement part for these old viking window locks. The keeper is very thin.

Hi There,I am trying to find replacements for this window latch. I do not now know the brand. The latch, as shown is for a horizontal sliding vinyl window which slides right to closed. The latch is mounted on the left outer edge of the window frame. The locking lever swivels up and down. Up is unlo ... (cont.)