Viewing all customer Discussions for:

39-105 Stainless Steel Detach Clip

Hello, I recently ordered 2 of item 39-317, and 2 of 39-318 along with other parts. The 39-317, 39-318 were not the exact copy of the window part at my home. The holes do not match up and the arm on the new piece seems to be shorter.The window information is NFRC 100/200, series: twvca, code: PAT(V ... (cont.)

I'm interested in a replacement of the clip shown here that has a number 3 on it.

I'm looking to get this replaced and also need hinges I don't have a photo or measurements on the hinges but hopefully it's something that can be matched with the operator any help is appreciated thanks Rob christian

attached are pictures. what I am confused about is there is not a slide on this arm to secure to stud it is press in.

This part is on a MW window.

I have a Silverline casement window in the kitchen, both right and left handle turner are broken and I would like to replace them , Is that possible and which product do you suggest i should get from your catalog. Thankyou Jay

There is an operator arm that says "Truth", and it looks like it connects close to the sliding pivot of the window. Thinking there is a screw that should go in here?

Hello, I'm looking to replace approximately 10 encasement operators from the attached photos (5 RT, 5LT)...I recently received an order fro swisco but they unit(s) do not fit.Thanks!

Hi Tom. Could you help me find this piece? It's the small piece right under the corner of the window frame. I took a window apart and lost it. NOT L 31538 B. I need the little one that attaches to it at the end. THANK YOU

Aloha! My windows are only about 10 years old but the humidity has missed the mechanisms. The crank is ok, the hinge is ok but what appears to be rusting out is the mechanism that connects the crank to the hinge. I watched your video on how to take it apart, but there doesn't seem to be an obvious ... (cont.)

This is what I had broken?. I believe plastic clip come with the bracket. Please let me know if you can help with replacement parts.

I need the piece that slides in here that connects to. The Window

Need the track/ guides for newer replacements Also the pin that mounts on window sash for the short arm

Howdy! My casement window operator arm is no longer attached to the window. It looks like I'm missing the pin that goes through the operator arm into the window. Can you advise? Many thanks! Stee

I am looking for these parts... Need 6 of each The last three pictures are the same part that holds the metal locking mechanism. The first two pictures are the same part, connected to the window and hold the "knobs" on the metal locking mechanism. Thanks for your assistance. Greg ... (cont.)

ok

The clip that goes on the window sash for the short arm. I don't know what happened it's the one with the two screws that goes under the bottom of the window in the corner

This looks to be a GU manufactured window, There aren't any part numbers listed on the crank.

Us.pat.0.247.270 - ca pat 2.248.439 3"- from screw hole - to screw hole Arm - 9" extended

Good Morning Casement window crankIf you have I would need a left and right side. The window was install when the house was built in 2004Thank you Mike