Viewing all customer Discussions for:

58-135 25ft Bubble Seal, 3/16" x 11/32"

We have Certainteed windows and need to replace the weather stripping on the front four casement windows. Company is out of business. Can you help? Pictures included. The T- track is 5/32" and the foam part measures 3/8" across.

Hi, I wonder if you can help me to identify what type of seal I should have. Thanks a lot!

The seals on these windows are in desperate need of replacement. If you have a list of known parts for these windows I'd appreciate any info you have on them! I already have purchased replacement pivot bars for them from you.

Trying to find this bottom seal for tilt windows. If not possible, maybe a replacement? Measurements might be slightly off (20yo windows). Base strip: 3/16'', Height: ~3/8'' or ~7/16'' Any recommendations? Thank you!

Below are picks of the 3/16" backing weatherstripping that is on the jamb of the door. If the strip was not bent over and was standing up straight on the t molding it would measure 1/4" high. You can see white marks on the weather stripping on the door jamb photo that shows where the door comes in ... (cont.)

This is a gasket that goes on a door frame of a patio sliding door. so that when the scree door is closed there is no gap between the screen door and the glass sliding door.

Side weather stripping, that fits inside kerf of window. Window built in 2004

These windows are made by Ellison Windows from all the research that I have been able to find. They are Series 200. I am looking to see if the bottom seal can be replaced. Also can the felt on the edges be replaced? If you need further pictures please let me know.

I need to replace the rubber weatherstrip on our Pella double glass doors. I believe that it is the 3/8 inch gasket that you sell but want to be sure before ordering. The doors are wide, tall double pane sliding glass doors installed in 1992. Thanks

All of our windows have the weather seal drying up & falling off..After talking to an associate at our Menards in Ankeny is we ordered a piece of T- slot foam filled bulb weather seal. This was 270 . It was too wide to fit into the window, so needed to know if the other size you have would be not a ... (cont.)

2015 Solar Innovations panel sill weather strip

This weather strip goes on the active panel where it meets the stat panel when closed.

Hello we are wondering if you had a bigger size of this bubble seal at a 3/16" x 5/8" measurement. Thank you.

Do you have a replacement piece or know where I can get one. About 24" long

3/16 X 5/16 - measured with calipers. The 5/16 is the approximate diameter of the foam seal. There is no names or marking on the waertherseal.Thanks - Kathy

The "T" part of the strip is 1/4" not 3/16". I can not find it on your web site. I contacted the manufacturer and they gave me your name. If this can not be replaced with a like item, any suggestions?

Do you have these two parts for weather stripping replacement for a sliding glass door?

This slides into the bottom of my window.

I need the bottom weather seal for Crestline double hung window made in 2004

I have all 2006/2007 MW double hung vinyl windows across the house I'd like to replace the weatherstripping. The t-bulb is foam filled for the bottom, top and middle of sashes. Then, the rest is a t slot felt.