Viewing all customer Discussions for:

26-405 Rounded End Pivot Bar, 2-7/8"

Slidin Window Metal Pin which goes inside 8 lb Series 140 Quick-Tilt, Single

Looking for 2 I put a picture up with ruler showing the size

2.25" long, nose hole is threaded, has an offset

I need to identify a replacement part for this pivot bar.

Coil balance was 4 1/8 long by 1/2 to 5/8 thick

Hi There, I need complete set coil balance (left and right) for my window. do you mind which parts i need? appreciated

The one shown is not broken... need to find part #

We have a bay window with two series 4000 double hung (model 3B01) and both the pivot shoes broke on one of the windows. It looks similar to 15-177, but ours has a hole just above the metal shoe.Any help is appreciated.

Hello, Just got and installed a set of s140.10 coils and realized need pivot pins as well. The 26.405 holes location seems right but does it fit the coil shoe? Thank you

Help me find this part please

The above photo is only PART of the pivot bar for a Unishield window. (It broke and the other end is still in the window frame.) The piece shown is 1 3/8 inches long, 1/2 inch at the widest part, I see no markings on it. The window frame had two stickers on it that might help you. I've attached ... (cont.)

I have about 21lb window. It says 10k on the previous coil. Also i need pivot bar

The building was built in 2016 if that helps. I hope you can help! You always do!

I need the spring and spring housing and shoe

pat # 6983,513 & 5317971 letters A-F #10 top left corner PAT PEND

Hi. I am looking for coil balance for windows. Here are pictures. The measurements of the coil balance is11/2 inches wide by 1/5/8 inches long.Do you carry coil balances for windows? Thank you.

Hello! My pivot shoe and bar are broken. I have an Anderson window, as described on the sticker. Could you please help me with choosing a correct pivot shoe and bar?

G 10 I.

Pivot bar with A5 etched on one side?

How to install