Viewing all customer Discussions for:

58-182 .187 T-Slot Foam Filled Bulb Weatherseal,12ft

Greetings,I am trying to identify th manufacturer of my vinyl replacement windows so I can find the weather striping that goes on the bottom of the lower sash. The windows were installed in June of 2000.The locking hardware has "Prism" on it and I have included a picture of a sticker that is on the ... (cont.)

the rubber seal is foam filled and appears to be .300 in across. The retainer part is 3/16 inch wide and the base the bubble attaches to is 1/2 across.

Looking for new weather striping.

I have replacement windows with some worn out weather stripping. Attached is a picture. Thank you.

Good afternoon. I have a home built in 2001 with contractor grade double hung windows. I do not know the manufacturer. I need to replace window seals on the bottom of the window. Attached are photos of the existing seal. Note that the window seal appears to be a T-slot foam filled bulb weather ... (cont.)

Looking for parts simonton windows

I'm looking for about 30 ' of weather strip. Picture is attachef

I am looking for weather stripping for a kvw window that was install around 2003. Please let me know what part you think will work. Thanks

Seal on bottom edge of lower Superseal vinyl double hung tilt . Sun has destroyed all the seals where the bottom sash rests on the window sill. Sill seal on Superseal double hung has deteriorated due to exposure to sun. This seal attaches to the bottom of the lower window sash and seals against the ... (cont.)

Will this weather seal .270 T-slot work on my windows? Looking at ordering 5 of them if this one will work or if not then what will?

What weather stripping do I need? Not sure if this was a bubble-type stripping that has compressed with age or is another type. Also what quantity does it come in and what is the price. If it helps to identify the correct weatherstrip, this Plygem window was manufactured in 2002 or 2003. Thanks. ... (cont.)

I hope you can help me. This came off the bottom of my 23 yr old Simonton vinyl window. It slides on the very bottom of the window and when the window is down it keeps the rain, etc out. In picture#1, it is the outside part. It is suppose to have rubber on the piece on pic#2. I'm needing to replac ... (cont.)

I measure bulb at 3/8 wide. And side profile 3/8 using instructions from the video. But so dry rotted hard to tell

Looking for replacement weather stripping for a CertainTeed windows. have lower sash lift rail Part Number H6596MXX your parts numbers 58-171 and 58-182 look very close can you help me get the right one?

Hello! With the attached photos, I need help identify my window weather stripping in the picture, if you have it or do you offer something in its place? Channel = 3/16th" wide Brush = 3/8th" wide

Replacing all the window lower seals cannot find here they are fold inward lower windows seal snaps in grooves of frame with T shaped

This bubble weather strip seals the bottom of a double hung window. The track part of the strip is .187. I looked at your weather stripping and I believe 58-182 would work. Please let me know what you think.

need enough weather stripping for 10 windows

I think this is what I need. Ours are so old and broke it is hard to see and measure. The one with the red ruler shows the entire width of the plastic and the other one is just the part that slides in the groove on the window.

This is for horizontal slider windows on the porch. 25 years old. Any thoughts?