Viewing all customer Discussions for:

21-175 Pivot Bracket

Hi. The fixed insert in the track of my bifold door, against the frame, is no longer fixed. Of course I broke it trying to fix it better. It's plastic and I fear that I used a screw that is too large. So now it slides an inch or so away from the door frame, although it remains in the track. I c ... (cont.)

Are there replacement parts for the internal bifold door frame brackets that house the pins. It appears these brackets are removable due to the philips head screws. The bifold door pins have worn out the plastic pin housing brackets causing the bifolds to sag when the bifold doors are in the open po ... (cont.)

The plastic guide that fits in the rail, that the door peg sticks into, has broken. I can't find where to get a replacement. I'm not sure the age of the door or the manufacturer. The label is partly covered (see photo). Do you know if the part is still available anywhere? Thanks. ... (cont.)

Dear Paul: In these bifold mirror doors, I'm missing several parts. The sticker on the back says Arch Mirror and the track measures 1 3/16 " X 3/4" measured outside.Please advise if you carry the parts like pivot bracket, roll guide, corner connector, pivot pin, screw driver bottom pivot that would ... (cont.)

I am looking for replacement parts for a Stanley Mirrored bi-fold closet door. I need the floor channel and the four roller assemblies that fit in the corners of the inside of the doors. Channel is 24 inches long, 1 inch high and 1 inch wide. Roller assemblies have the number 4405-R . Please h ... (cont.)

Need the part that slides inside the track.

I bought a 36" x 80" Gardner bifold mirror door for my closet around 2011. The track pins-parts (as shown in the photo) have broken. Hinge side is fine. Bifold center pivots are fine. But the outer pins on both the upper and lower have left the nylon guide wheels and just won't stay in place if I tr ... (cont.)

I need this bottom door pivot...

Upper and lower pivots for two stanley 24 inch mirrored doors. They are separate, not set up as a 48 inch door. Has upper and lower tracks. I need all the pivot hardware to fit in the plastic corner blocks to adjust them to open and close properly.

I am not sure what part may be needed but this closet door no longer works properly. It is fine when open but when you close it the top pivot rod on leading part of door comes out of the roller and the leading edge drops down. I have attached some photos with descriptions. Do you think a piece is mi ... (cont.)

21-455 has how many rollers and end guides. Will it hang two doors or do need to buy extra set of rollers and end supports? Thanks, Peter

I am looking to replace the bottom track of Stanley Monarch sliding glass doors 50822981 / 64564-001. I also need the rubber rollers for the top track guides. Can you assist? Thank you