Viewing all customer Discussions for:

10-324 24" Shower Sweep With Drip Rail

Trying to find a new bottom rail for shower door. Screw boss that's holds bottom rail to side vertical rail has corroded and screw will not hold anymore causing bottom rail to drop and not close properly.

Hi, could you please help me identify a matching sweep that would work with my shower door (photos attached). Thank you very much!

My drip rail is 24" long with 4 screws. The sweep has fallen off (rotting). Your 10-324 looks similar but it only shows 1 screw hole? The shower is at least 20 years old and chrome framed.Thank you for your help.K.

Is the sweep included with the order? Can a copping saw be used instead of a hack saw? My length is needed at 21 1/2 inches, so I would assume that 2 cuts one at each end will have to be done to align the screw openings. Thanks much

the slot that the strip slides into is 1//4" wide at the bottom of the door sweep

Looking for a replacement for the bottom rail on the shower door. It measures 20.5", and I can't find anywhere that has something this short. Help?

Can you tell me what is (based on pics), the part# Thanks

This is the original shower drip rail system (YR 2004), on my shower stall. The only thing I have had to do is replace the rubber sweep. I'm not sure how the original rubber sweep was attached but it fell apart many years ago. The rubber sweep you see in the photo was purchased at Home Depot but it ... (cont.)

I'm looking for a replacement for this piece of rubber that fits into a t-slot and hangs down below the door of the shower. It seems like the rubber comes off at nearly a right angle to the t that slides into the slot of the aluminum lower piece. The whole door is at least a meter wide. ... (cont.)

Do you carry the rubber gasket that would fit into the this aluminum drip rail.

Recently water started coming out from under the shower door. I'm looking to replace the vinyl sweep. If that does not work, I think I might have to replace the aluminum channel. Do you carry these replacement parts. Note that there are two screws on either side of the channel.

Hi, I need help finding a replacement sweep that will fit the bottom of my swinging shower door. The slot where the sweep will hold is about 1/2 inch height x 1/4 inch width. Please see attached photo. Thanks

This gasket sweep slides into a t shaped channel but I cannot find the right size anywhere. The door is 24" and from the early 1980s. Advise? Thanks.

I need the shower sweep and the attachment for a 22" shower door.

Would you have the replacement for the vinyl part that fits into the metal piece pictured. And then would 2 face type work to put it back on. It fell off the other day. The metal is 25" And the vinyl or rubber is 1"

Hi - this is an old shower door (pre-2005); there was once a rubber strip of some sort and I can identify what it is missing or where it goes once I have the part. I thought iit was something that slides into the large groove but I may be wrong? Does it go behind it?

Need a replacement for old (25 year old installed) Basco shower door sweep. Hope you can assist me, you're my last hope. Thanks. Tom

Shower sweep

I am looking for a Gold Shower Door replacement rail that can hold a vinyl sweep. It can be plastic or metal - as long as it is looks like gold or brass. Thank you. Larry

I'm trying to find a shower sweep. 19 in x 3/4 in grey sweep with a hook slide. Do you have anything That might work.