Viewing all customer Discussions for:

10-324 24" Shower Sweep With Drip Rail

The shower door is loose at the bottom, what are the replacement parts for the parts shown in the picture? And also what is the shower sweep show I buy for this drip rail? Thanks!

I need new shower door sweep for old shower door. Made by Aquaglass and is 213/8 long and on with no screws. Do you anything I can use?

Hi, My shower door sweep with drip rail 23.25 inches needs replaced. I removed the two screws and the driprail remains permantly attached. Are there any additional screws that need to be removed? When the 24 inch Swisco shower sweep arrives, how do you relace the old one ? My original shower ... (cont.)

Need a shower door sweep replacement with distance from end of door to screw of 2 1/2 inches

Does it come in 35"?

I was looking at your shower door #10-324 sweep that is essentially the same product as shown on my picture above. However this product is attached on the bottom of the door. #10-324 is attached on the side of the door. Would you have the same product as shown on the picture? If not do you have flex ... (cont.)

Would you please help tell me what I need to order to do these repairs myself along with any handy pro tips to make it easier and be a pro job?

22 inches long, 1&1/2 inches wide This is the best I can do for photos. The lip is suppose to catch the track, but it does not This is a picture of the outside door of my shower door. The lip will not "catch" on the railing......at least it will not stay in the track

Hello,I'm looking for stuff I don't know the names of and hope you can help. The piece that goes on the bottom of the door is shown in the first two photos I uploaded. It measures 23Wx3/4Hx5/8D. The larger piece is the bottom of the door frame. It measures 34.25Wx1.06Hx0.93D. The grey gasket measure ... (cont.)

Need bottom vinyl door sweep for Fiat acrylic steam/shower unit.

This unit is about 26 years old. I need to replace the drip cap vinyl strip VS91 at the bottom of the 22" wide hinged door. Alternatively, we could replace the entire drip cap and vinyl structure. Which product is most likely compatible? Thank you much for your advice.

Water dripping outside; should I replace the whole thing or just replace the sweep?

So I am trying to fix the shower and it is in a mobile home an old year. So I do know it is not l level on the bottom and I am trying to watch videos on how to fix this, but there is also no guard so water leaks on the bottom and just runs right out in the floor. Any help would be appreciated ... (cont.)

I am curious to know what the hole locations are on the 24" piece. How far from the ends are they?

Hi, Checking in to see if you guys carry this shower door magnet. Tab is bent/broken and won't stay in place any longer. And then I am looking to replace the rubber seal from the bottom of shower door. Do you guys have either of these?

1st photo bottom of framed shower door. It is 22 1/2 inches long. The others photos are of my shower latch

Hi, I need to replace this shower door sweep. It's 21" long and the holes are inset 1 5/8" and in the middle. Can you help me with this? Thanks. The rubber part seems to protrude .5" from the bottom of metal part. Does this work for you? Thanks.

I'm wondering if your product can solve my problem on an old shower door. Photos follow

The diagram says that the ends holes are 4" in from ends. How many holes are there and locations? Also if need be is it difficult to drill new holes? Would I need a specific drill bit?

House was built in 99' shower does not have a piano hinge on the verticle. It is a pivot at top and bottom of door in the header and the threshold. Framed door does not have a screw in gutter or sweep. I am assuming this is a double sided tape deal. I cannot see double sided tape. ... (cont.)