Viewing all customer Discussions for:

26-186 Weep hole cover, 1-7/8"

I know you sell two window weep covers that are 1 inch long. Can you tell me which one will fit? I am in the desert in California with red ants are abundant.

Can you help Me complete a replacement window job? The installer left out the lower vent plugs. Thanks, Andy

14 years old and dried out in the sun... tried removing one to clean out the weeps but it cracked. Time to replace the covers. Could use some assistance identifying what could work. Full width looks to be 1.5 inches wide (gap is 1.25 inches), and height looks to be just under .5 inches (gap is .25 i ... (cont.)

I am in need of weep hole covers for CertainTeed Windows that were installed in 2007/2008. I have attached pictures and the size when I measure them are: 1 3/8 x 7/16 Do you carry these?

i'm interested in your swisco 26-417 weep hole cover. the weep holes in my windows are simply slots measuring 3/8" long x 3/16" high (photo attached). it looks like the 26-417 could work if i simply extend the width of the slot from 3/8" to 1" and snap the cover in place. would you agree? am i looki ... (cont.)

window drain small plastic in double paned windows

Picture attached. One side broken. 37.5mm x 11mm or image shows inches

Can you let me know if you have one that's 5/8 X 2" and the tabs are 1 7/16

Hi, I need some of these weep hole covers. They are 1.2"-wide overall, and look like they should fit into a hole that is about 1.1" wide and 0.2" tall. Thanks!

House built in 2004, no markings on any windows for manufacturer. Slot is 1/4 x 1". Most of these are sun rotted, flaps missing. I counted 36 weep slots to have these

Looking to replace a bunch of weep hole inserts that have broken and fallen out of my windows. The color of the window frames is kind of taupe. Attached is a label from one of the windows. If the codes identify the manufacturer in some way, I would love to have that information. Also attached ar ... (cont.)

Hi: My Milgard aluminum doors has 28 years and they have a drain flap and it is broken. Are they replacement parts for the drain flaps? Where can I get them? Pictures are taken at the bottom of the door from the outside.

None of my windows have weep gates and insects are getting inside

Hello - I have a screened in porch that accumulates standing water in heavy rain. I need to make couple holes in thin metal or aluminum kick plates as shown on the attached photo. The rectangles are the low point of the floor. Not sure if a weep hole cover would work in this situation and if so doe ... (cont.)

Do you carry anything like this?

Need 12 covers for windows probably 12 years old

Not sure if you have, size is 1 3/16 of an inch of a opening.

1 5/16" x 6/16" from what I could measure. They are put on the inside of the window from the bedroom. Confused on what will work. Hope the pics help! Thanks Bobbi

Hello Swisco, I found a picture of my exact weep hole flap from your website. I attached it to this posting. Do you have a replacement part? Thank you so much for your help. Thank you, Robert

Looking for weep Hole covers for pgt windows.