Viewing all customer Discussions for:

81-310 Roller Axle Repair Kit

Measures 2" tall 2" long and 5/8" wide wheel is steel and approx 1-3/4"

The wheels are marked Killian Syracuse New York. The door was installed by Erie glass company. The whole assembly slides into the door and the one notch sits on the door while the other is held in with a plate that's screwed on.

No part numbers.

House was built in 1972 and we think it might be the original door

I am looking for this roller for sliding door. I have attached pictures below. Please let me know if you need any further information. Thanks Lisa

I need 1 1/8 in nylon wheels tandem or single

Hi, I removed these rollers from my daughter's very heavy glass patio door. I spent 2 days and many hours trying to find the entire bracket units. I even tried finding just the rollers themselves since I had the brackets intact. No success. I had to put them back on the door & reinstall door ... (cont.)

Hello, I have attached a several closet door rollers that I am trying to identify/replace. If you sell these, please let me know the total amount for a set and the part number as well.

Roller

My sliding door is 30 years old and I need a new roller assembly. The pictures above were roller I bought at Ace Hardware and they ran out. I need one more to complete job. Notice the screw that is used doesn't have a nut on end but rather the screw goes through a housing neck with does not require ... (cont.)

I need 2 of these. Possibly 81-269.

Door is a heavy aluminum door, I believe by MI. Length (as shown in photo): 2-1/4"width (widest point): 9/16"Height (casing only): 1-1/8"Wheel diameter: 1", concave roller Marked with "Ultra" brand. I gather from searching that they are not made anymore.

Need to identify and purchase two single rollers for my sliding glass door. The dimensions and diameter of the wheel is 2 3/8' L x 1 3/16' high and 9/16" Wide as shown on uploaded picture with a 1 1/8" wheel diameter. PLease advise.

Trying to replace my sliding glass door rollers. It is a complete track with rollers that go on the bottom of the door. Help please!

The rollers are installed into the styles

Need 2 door rollers - tandem 1 1/8 inch rollers 1 In wide at tabs Body 3 1/16 long frame 1 1-16 tallDan

Wheels are 1.125" diameter. Frame is about 11/16" thick. It's about 7/8" thick at the flared section. Overall length from mount hole to end of wheel is about 4.5"

"ID" on metal part Plastic wheel "PAT. DWB -32 S&S BEARINGS" We need the part on the fotos to change it. All wheels are broken.

I have older custom made mirrored doors for my closet but I needed to replace the rollers. I went online and was able to find the wheels, but when I tried using them they did not fit. I made sure that the part that slips in was round and matched the bracket and was not the square ones. I want to eit ... (cont.)

I have not been able to find any part number or manufacture marking on the current roller assembly. The pictures provided include the dimensions. The roller assembly has a nylon/plastic single wheel that is 1-1/8" diameter.