Viewing all customer Discussions for:

81-310 Roller Axle Repair Kit

It's for a1971 key west mobilehome glass closet hinge 11/4" wheel, has no number on it

We have 16 condos in our building all with 96" tall Windoor doors and sliding screens that are about 15 years old. Over 200 screens with two rollers each as shown below. The roller is nylon, I guess, with SS bearings. 1 and 1/2" diameter and 5/16" wide. The opening in the screen frame is 3/4" wide. ... (cont.)

From an older patio door. Has nylon wheels, detent protrusions, top screw adjustment

If the rollers and the bearing with the shaft is available I can insert them into the metal housing. The plastic roller and bearings that are worn out.I currently need (4) rollers with bearing and shaft.Thank you Tim Dodge DBA Mr Fix It.

Rollers snap into assemblies. They are 1 1/4" dismeter

No identifying letters or numbers on the roller.

From circa 1995 Marlin Windows, in California. Marlin Windows has undergone ownership changes since then so they recommended I use your service. Thanks!

Could please find the attached rollers? I need 12 pieces. thank you John

Looking for a replacement for this Nylon door roller. The wheel is about 1 1/2" wide and the metal assembly is about 2" wide.

Attached are pics of wheel assemblies that I am having trouble matching. I could have sworn you carried them at one time but I no longer see them on you site. The distinctive feature is the two flared cut-outs on both lower sides of the assembly. I have ordered a package of 1 1/8" wheels & several p ... (cont.)

Hi - I'm looking for replacement rollers for this door. Any help appreciated!

Hi can you identify my sliding door roller? Length : 4 7/8 in Width : 3/4 in Height: 1 3/8 2 Wheels: 1 1/4 steel and plastic with bearings

For Elfa wardrobe. Alisons Doors

Would u have replacement track and wheels for these doors. They're bypass doors

my rollers wheels are 1 1/8", the length is 3 1/8", the height is 1 1/8", and the width is 3/4". Canyon recommend a replacement as I see a few in your catalog that may work. I was hoping that you have an assembly with ball bearings that would fit my door. Please help!

Total length is 5 inches. Door is 1 1/4 thick. Rollers are 1 1/2. The door is approximately 20 years old and I cannot find the manufacturer name anywhere so I was wondering if you could tell me if there is a replacement for this. Thank you

These rollers are from a vinyl clad patio sliding door. The closest match I found was the 81-030. My part is 3 1/8" long, 3/4" wide, 1" tall, and the rollers are 1 1/4" diameter. (The 81-030 is 1 1/8" tall, but I don't think that will be a problem.) The main difference is my rollers are nylon. Doe ... (cont.)

The wheel is 1 3/4 Diam 5/8 thick nylon the hub /bearing assembly is 3/4 outer diam , roughly 1/4 inner diam and 1 3/16 long i believe the door is a acorn door but no actual markings probably from the early 70s

Metal is all brass. Old measurements (some wear may have occured?): Wheels measure 1-1/8" Housing meaures 3-1/16" long, 11/6" wide, 1-1/8" deep Flange has hole, not slot, and is above the housing

There is V embossed on one side of the housing at the opposite end, toward the screws. I believe the doors are Pella doors. Thank you.