Viewing all customer Discussions for:

81-279 Patio Roller Assembly, 1-1/4" Steel Ball Bearing

Need these parts

Need new rollers for sliding glass door wheels are 1.5 inches, width 3/4", and length 2 1/2 inches.

ball bearings crushed in this roller door track in good condition door is heavy hired someone who took out rollers was able to replace front roller from HD we'll see how long last MH home Palm Harbor built 1991 so assume sliding doors to sunroom installed at this time. I hope pictures are visible. I ... (cont.)

Roller bearing assembly NOT wheels

This door was installed new when the hose was built 20 years ago. The pictures are taken on 1/4" graph paper(I think). Unfortunately I did not measure anything or put a ruler in the pics for size (uhg!)

I do have pictures or anything else ------ I don't remember where i got them from before but this the3rd patio door i ran across with that type of roll.

Please let me know if you carry this assembly. Thank youBob

Need help determine the replacement for this

Single roller, unsure of wheel diameter at this point. This is a heavy alum door and window

Hi, can you ID these rollers for me? Thank you

Need 6-8 replacements to match as close as the photos

Can you identify this part number for me?

Trying to identify the replacement wheel assembly. There is no information listed on the door or The wheel assembly. I do not know the brand/ manufacturer of the door. 2 pictures attached. 1 picture shows Part with wheels in place, the other picture shows part with missing wheels Thanks. ... (cont.)

We have an "ANSI AAMA 101-85 SGD-R20, Series M-800/M825/M850 door". We are needing replacement rollers for the glass sliding door, bottom.

Hello, Need some help figuring out what rollers i need. Josh

Looking for replacement rollers for glass door that are about 50+ years old, hopefully these photos will help to identify the parts we need, thanks for your help

3/4 inch wide x2 5/8 inch long. What do I need?

Dear sirs: I have an older sliding glass door (probably 30 years) It is vinyl covered aluminum door The rollers are not the standard wheels but use a series of rollers to move the door Had 2 sets. The back set is worn out and you have to lift the door to make it move Please let me know of any addit ... (cont.)

Rollers 2 only on bottom of door. Held in place by screw from edge of door and one from above. Markings: Row 1 "A-S" Row 2 "MYC" Row 3 "7867" Thanks for help locating part. Zack

This is a caterpillar roller from our door. I'm searching for a replacement. This type of roller I'm told, is no longer made.