Viewing all customer Discussions for:

26-228 Left Hand Tilt Latch, 2-1/8"

Hi, I had purchased these latches from your shop several years back and now need more. Numbers on the back: 11147 L 3 PAT,#4,901475 I would need 15 of each right- and left-handed latches (a total of 15 pairs; 30 count total). It looks very much like part number: 26-228 (R-handed tilt latch ... (cont.)

Hi guys! I was hoping to order some tilt latches for my house in Wilmington, Delaware. The house had Mastic windows when we bought them, and I've broken a few them in the past few years. Do you sell a replacement part for these? Thanks, -tom

Window sash release lever 5-pics (3-pages) would need them in white.

I have a bunch of windows that need repair. I've found most of the parts I need on your site (spiral balances, pivot shoes, tilt latch actuator, etc.), except I cannot identify the internal window latch pictured. The picture shows the L & R broken parts, with the latch ends missing. Please let me ... (cont.)

I was told I need part 26-228 and 26-229, but the measurements didn

My windows were replaced in the 1990's by a handy man. I can't contact him. I think the company was located in PA. I need help. I have several broken tilt latches. Right and left. Two windows I can't even open because they are broken. The number on the part that slides with the spring is 535B. I wou ... (cont.)

I need replacement for window locks in attached file. The larger window lock has part # of 536-B w/ a capital L (possibly for left side). The associated window has "DACO" inscription. I don't have any additional info for smaller lock.

Hi The moving piece inside is broken, I should buy both right and left. There are no markings on the window or on the latch 3 1/8" x 1 3/8 " 1/4" thick 2 1/8" between holes while plastic it is screwed on top of the frame, it is not recessed into the frame (I would like the same bec ... (cont.)

Hello I am looking for the plastic window latches with snap in slid releases. These are for the windows you see in the pictures, unfortunately there are no names numbers or markings on these windows. I need both the left and right hand sides for a number of these windows. We would appreci ... (cont.)

Hi, I need to replace a few window latches that have broken. The dimensions are as follows: 2-1/8 inch attachment screw holes 3/4 inch from screw hole to end of casting (not including sliding latch) width is 1-3/8 inch thickness is 5/16 inch Based on your site, I see either the 26-120/12 ... (cont.)

Hi, I need couple window parts, I will take photo and send them to you, please let me know if you have them, thank you

Need at least 3 pr. of window latches. Not the locks but the plastic latches that snap into the jamb. I was told i need 26-121 R and 26-120 L Can you help me out? Thanks! Steve

I have several windows which need this part replaced 26-234 but have one or two windows that also need the internal latch that coordinates with this actuator but i can not identify it anywhere

Looking for this part. It is not surface mounted like most I see on your website but is located inside the sash of the window. It looks similar to some that are surface mounted. Do you have any suggestions?