Viewing all customer Discussions for:

26-229 Right Hand Tilt Latch, 2-1/8"

Hello. I have both of these broken on a window and it won't stay in place. I can't find a manufacturer printed anywhere and was hoping someone experienced would be able to offer assistance. Thank you for any feedback on part numbers or suppliers.

Looking for replacement internal vinyl window tilt latches and clips to operate the latch .

Hi I'm looking for these old mastic tilt latches

Hi, looking for multiple replacements (minimum 20) for the window sash release level in photo. I do not know the brand of window. It does not marked on window and where from previous homeowner Reno. Dimensions for the lever: Head is 2" L x 1/2" W. The depth varies as the top is sculpted to provide a ... (cont.)

I need to replace the latches but my window has that brown snap in slider. Can be white. I thought it was the 26-132 but I don't.t think that accepts the snap in latch. Help. Thanks

Need part number for replacing latch both left and right.

I'm looking for a replacement for the attached part. Overall length 1- 5/8". Width 11/16". Pin 1/8" wide. Pin width 3/8". Color tan. I don't see any numbers on name on the part. I also don't know the window maker.

Looking for a tilt latch. Uniframe

Need a few replacements for these snap in sashes. Cannot find a brand for the window

? Caradon Ariel double-hung window (1999) ? Recessed (mortised) design ? Approximately 3¼" overall length ? Approximately ¾" wide ? Two countersunk mounting screws ? Internal spring-loaded latch ? Same style of center release tab

Circa 2002 better-built tilt window, rectangle part approximately 2 3/4 inch x 1 1/4 inch. Marking says "RAISE SASH 2" MINIMUM TO TILT" - "TILT" written diagonally. Thank you!!!

These are silver light windows 2003 window tilt plastic that need to be replaced that hold the window in need a part number and the part on where I can get it?

I have a series 0901 double hung window and need the slide replacement. What part would this be?

Screw holes 2 7/8" center on center 3/4" from center of front screw hole to end of latch plunger is 3-16" thick width is 1/2"

I have Mastic window locks so I'm assuming the slide locks are the same brand. They measure approx. 3 1/4 × 1 3/8. I need 3 of the right side slide locks.

It's a plastic piece that slides left to right that unlocks the window to fold down.

Can you identify the replacement parts I need to replace the left and right hand internal tilt latches? The latch is 4-3/4" long and 1/2" wide?

Actuator is 2" long by 7/8" wide Latch is approximately 21/2" to 2 3/4" long. The tip is broken off.It is 5/8" wide.

Locking mechanism on a vinyl inside window , push up both top and bottom latches to unlock the window to swing it out into the room. As you can see , one of the locking tabs is broken and won't allow the latch to stay in place and function.I hope you can help me with this item as you did 3 years ag ... (cont.)

We have UniFrame double hung windows throughout our home. The kitchen window was missing one the left sash latch when we bought the house, but the window continued to function properly otherwise. now the latch on the right side has broken as well. we're interesting in finding out if these latches ca ... (cont.)