Viewing all customer Discussions for:

26-229 Right Hand Tilt Latch, 2-1/8"

This latch is 1 5/16" long and 9/16" wide. The two prongs that snap into the window mechanism are 5/16" long and centered below the thumb latch which is also 5/16" long. I ordered some latches from you a couple of years ago but they are too small.

I can't seem to find that window latch size if you guys could help me out much appreciated

I believe the windows are from 2015 most likely bought in sears so finding any replacements has been hard. Any help?

I am needing 2 sets of sash releases for an unknown manufacturer. I was told your company would probably have what I needed. I am delighted to find that you also carry the spiral springs. I'll have to measure the diameter as indicated. If you can match the part pictured then half of the task is done ... (cont.)

Hello, I am seeking two pairs of vinyl window triggers per attached photos. Thank you.

Looking for window parts for windows installed in 1993 made by IWC. Do you compatible parts? International Window Company Parts like White Tilt Latch for vertical sliding vinyl windows

Hello, I am needing two parts. The slide piece that says "Reynolds" and the key to pivot the window. Please See pictures

I would like to purchase four replacement sash release levers but I am not sure of the correct size. The measurements are 2" length and 7/8" wide but because the tabs that hold the lever in place are broken, I don't know the depth. I do not know the name of the window manufacturer. If you want any ... (cont.)

The windows are old but the window will not catch due to broken right and left window catch that realizes for dropping window to clean

Hello, I'm looking internally latch, top of the latch and screen corner thanks

Everclad window has a left and right tilt mechanism that the ends are broken and no longer holds the window from tilting when the window is unlocked. Ruler in photo for approximate size. I could not find it in your catalog. Pictures are of the part both installed and removed. Thanks, Dan ... (cont.)

need tilt latchs for Allside window....about 20 years old

I am looking for tabs that lock these windows into the sash at the top. I've been hold they are Hansen windows although I am not 100% sure. Enclosed is a tag I was able to find. These windows are aprroximately 102" vinyl windows that were put in about 20 years ago.

Do you have a latch similar to this one? It has a lock on it that none of the ones in your catalog appear to have. Thanks, Brian

I am tring to find replacement tilt-in latches and buttons.

Hello, In need of a right and left tilt latch replacement. Looking for suitable replacements, and hope you can provide recommendations. Any assistance is greatly appreciated. Thank you.

Hello. I'm in need of both a left and a right. It doens't quite match with any of the items I've found on your site so far, so maybe the photos will help. I haven't found any brand marking on the window itself. And the only numbers on the latches are a "2" on the fixed part, and a "3" on the part th ... (cont.)

need this part

Retainer button vinyl window

I just recently bought a house and the windows are uniframe. The tilt latches are broke on a few of them which has resulted in the glass getting broken from them falling out of the frame. I'm having a hard time finding the proper replacement parts if someone could point me in the right direction pl ... (cont.)