Viewing all customer Discussions for:

26-229 Right Hand Tilt Latch, 2-1/8"

Window sash release lever 5-pics (3-pages) would need them in white.

I have a bunch of windows that need repair. I've found most of the parts I need on your site (spiral balances, pivot shoes, tilt latch actuator, etc.), except I cannot identify the internal window latch pictured. The picture shows the L & R broken parts, with the latch ends missing. Please let me ... (cont.)

I was told I need part 26-228 and 26-229, but the measurements didn

My windows were replaced in the 1990's by a handy man. I can't contact him. I think the company was located in PA. I need help. I have several broken tilt latches. Right and left. Two windows I can't even open because they are broken. The number on the part that slides with the spring is 535B. I wou ... (cont.)

I need replacement for window locks in attached file. The larger window lock has part # of 536-B w/ a capital L (possibly for left side). The associated window has "DACO" inscription. I don't have any additional info for smaller lock.

Hi The moving piece inside is broken, I should buy both right and left. There are no markings on the window or on the latch 3 1/8" x 1 3/8 " 1/4" thick 2 1/8" between holes while plastic it is screwed on top of the frame, it is not recessed into the frame (I would like the same bec ... (cont.)

Hello I am looking for the plastic window latches with snap in slid releases. These are for the windows you see in the pictures, unfortunately there are no names numbers or markings on these windows. I need both the left and right hand sides for a number of these windows. We would appreci ... (cont.)

Hi, I need to replace a few window latches that have broken. The dimensions are as follows: 2-1/8 inch attachment screw holes 3/4 inch from screw hole to end of casting (not including sliding latch) width is 1-3/8 inch thickness is 5/16 inch Based on your site, I see either the 26-120/12 ... (cont.)

Hi, I need couple window parts, I will take photo and send them to you, please let me know if you have them, thank you

Need at least 3 pr. of window latches. Not the locks but the plastic latches that snap into the jamb. I was told i need 26-121 R and 26-120 L Can you help me out? Thanks! Steve

Please help me identify these parts. 1. I need a left and right tilt latch. 2. I need 2 pivot lock shoes. The dimensions look like your part number 15-135, but it is slightly different in appearance. 3. I need one lock and keeper 4. I need one pivot bar, but I could not remove it to get a b ... (cont.)

I have several windows which need this part replaced 26-234 but have one or two windows that also need the internal latch that coordinates with this actuator but i can not identify it anywhere

We have a ton of these windows in one office building and many are bad. They are tilt in double pane windows. Here is a pic of outside - inside and a side view for width. Please let me know what you have. Thanks Sharon

Looking for this part. It is not surface mounted like most I see on your website but is located inside the sash of the window. It looks similar to some that are surface mounted. Do you have any suggestions?

26-229 is white

What is the difference between product 26-229 and 26-121. Their measurements are pretty much the same except one is slightly longer. The screw positions and the width on the edge are the same. One measurement is not shown is the width of the triangular latch that springs out and locks on to the r ... (cont.)