Viewing all customer Discussions for:

89-042 Multi-Point Strike Plate

We are missing the part of the sliding door that the lock/handle latches on to. In the attached pictures, doorlatch1.jpg, is where the part is missing (it was lost during construction). This door is about 9 years old. On the slider side where the lock is, the measurement height is exactly 12in. ... (cont.)

Hi, I need a replacement striker for my sliding door. I purchased item 89-030 but it was too wide and didn't quite work for my sliding door. Are there any other strikers that I should look into?

Slider has the Milgard symbol on hardware but no other numbers.

I ordered the 89-030 multi-point striker but this will not allow the door to close flush enough. There was never a striker plate installed when the door was installed. Hoping you can help me order the correct part. Thank you.

I believe it may be this part 82-080 The cheap die cast on my patio door broke in half.The spacing is 4-15/16"

i have a 2018 Tuscany Milgard 2 sliding patio door. looking for a keeper for 2 point mortise lock. picture of the keeper attached. if you have the 'keeper' please provide part number, link to pic and how to order. thanks

do you have this

The striker/strike plate is missing from my sliding patio door. What part would fit this door? Thanks!

patio sliding door

Having problems getting door to lock 1. Striker plate in door jam may be missing parts if so what do I need. 2. I installed 2 brass screws in lock (see brass heads in pic) that were missing. 3. One claw is positive up and down with locking snib but other claw is only positve with snib in one direct ... (cont.)

Here is the system i have i need to get the missing peaces. The keeper is missing all together.

I ordered 89-043, 89-042, and 82-080. My door is missing the striker plate. I attached the following pictures of the outline of the striker plate is about 6" in length and about an 1" in width. Did I order the correct striker plate 89-042? Does 89-043 go into 89-042 and is it a requirement?I tighten ... (cont.)

Hi I?d like to order a handle lock set with keyed lock installed from your company, to replace my existing set which does not lock. I need two sets for two identical doors as pictured below. Can you please help me to learn how to measure to ensure I am ordering the correct sized set. Is there a s ... (cont.)

I have an existing slider that doesn't lock, the latch doesn't even come out of the door. I did read online to adjust the latch by turning the adjustment screws, but that didn't do anything. My question is, how do I remove the handle and how do I know if I need a new one? Also, the pics show the lev ... (cont.)

I have what I believe is a Milgard patio door lock. I need the strike plate door keeper that the lock goes into. Can I get some help on what part would work for this?

I need to have another one of these (see photo) for my 2nd sliding patio door handle to latch into with the double hooks that come out. Is this the right one? how deep is it? Mine is 5/16 ? Peggy

Hi There, I hope you are all well and safe. Was hoping you have a part I need for a 4 panel milgard 5621/5631 series sliding door. I believe I'm missing the strike plate. Also one of the screws that retains the spring is bent. Do you sell the screws, springs and strike plate? I "think" the original ... (cont.)

Do you carry this part? How can I order? Thanks

The inner door handle broke so I am needing to replace the handle all together.

Hi - We are looking for this piece with the metal piece in the center - suggestions? Thank you! Sam